| Power source mode does not change to ON or ACC |
Entry and start system (for Entry Function) |
 |
| Affected by wave interference |
| Transmitter battery |
| Electrical key transmitter sub-assembly |
| No. 1 indoor electrical key antenna assembly (front floor) |
| No. 3 indoor electrical key antenna assembly (rear floor) |
| No. 3 indoor electrical key antenna assembly (inside luggage compartment) |
| Engine switch |
| Wire harness or connector |
| Power distribution box assembly |
| Certification ECU (Smart key ECU assembly) |
| Power source mode does not change to ON |
Wire harness or connector |
 |
| Relay |
| Power distribution box assembly |
| Certification ECU (Smart key ECU assembly) |
| Power source mode does not change to ACC |
Wire harness or connector |
 |
| Relay |
| Power distribution box assembly |
| Certification ECU (Smart key ECU assembly) |
| Engine does not start |
ECD system (for Diesel) |
 |
| SFI system (for Gasoline) |
| Steering lock function |
| Immobiliser function |
| Wire harness or connector |
| Relay |
| Park/neutral position switch assembly |
| Electrical key transmitter sub-assembly |
| Stop light switch assembly |
| Certification ECU (Smart key ECU assembly) |
| New key cannot be registered |
LIN communication system |
 |
| Meter / gauge system |
| Reregistration |
| Electrical key transmitter sub-assembly |
| Steering lock ECU (Steering lock actuator with ECU assembly) |
| ID code box (Immobiliser code ECU) |
| Certification ECU (Smart key ECU assembly) |
| Additional key cannot be registered |
Entry and start system (for Start Function) |
 |
| Steering lock function |
| Electrical key transmitter sub-assembly |
| ID code box (Immobiliser code ECU) |
| Certification ECU (Smart key ECU assembly) |
| New key registration warning message is not displayed |
Lighting system (int) |
 |
| Meter / gauge system |
| Certification ECU (Smart key ECU assembly) |
| Unable to unlock steering wheel (Engine cannot start) |
Wire harness or connector |
 |
| Steering lock ECU (Steering lock actuator with ECU assembly) |
| ID code box (Immobiliser code ECU) |
| Certification ECU (Smart key ECU assembly) |
| Steering lock does not lock |
Lighting system (int) |
 |
| Wire harness or connector |
| Steering lock ECU (Steering lock actuator with ECU assembly) |
| ID code box (Immobiliser code ECU) |
| Certification ECU (Smart key ECU assembly) |
| Security indicator light does not blink |
Wire harness or connector |
 |
| Security indicator light |
| Certification ECU (Smart key ECU assembly) |
| Immobiliser system does not operate properly |
Communication ID registration was defective |
 |
| ECD system (for Diesel) |
| SFI system (for Gasoline) |
| Wire harness or connector |
| ID code box (Immobiliser code ECU) |
| ECM |
| System malfunction message is displayed on the multi-information display |
Entry and start system (for Entry Function) |
 |
| Entry and start system (for Start Function) |
| Steering lock ECU (Steering lock actuator with ECU assembly) |
| Certification ECU (Smart key ECU assembly) |
| Electronically controlled brake system |
| Fingerprint Authentication Failed and the Engine does not Start |
Wire harness or connector |
 |
| Code registration |
| Engine switch |
| Certification ECU (Smart key ECU assembly) |
| Cannot Proceed to Fingerprint Registration Screen |
Wire harness or connector |
 |
| Check customize setting |
| Certification ECU (Smart key ECU assembly) |
| Cannot Enter Fingerprint Registration Mode |
Wire harness or connector |
 |
| Check customize setting |
| Certification ECU (Smart key ECU assembly) |
| Cannot Complete Fingerprint Registration |
Wire harness or connector |
 |
| Code registration |
| Engine switch |
| Cannot Delete a Fingerprint/All Fingerprints |
Wire harness or connector |
 |
| Engine switch |
| Cannot Change the Fingerprint Authentication Customize Setting |
Wire harness or connector |
 |
| Certification ECU (Smart key ECU assembly) |