| Advanced park system does not operate continuously
|
Clearance warning ECU assembly
|
|
| Advanced park does not operate at night
|
Proceed to "Infrared light does not Turn ON at Low Illumination Time"
|
|
| The estimated course lines do not match the vehicle width extension lines when the steering wheel points straight ahead
|
Check steering wheel installation angle
|
|
| Adjust steering angle
|
|
| Check rear television camera assembly installation condition
|
|
| Adjust screen
|
|
| Parking assist ECU
|
|
| The estimated course lines stop moving before the steering wheel is turned fully left or right
|
Adjust steering angle
|
|
| Displays "Advanced park malfunction visit your dealer" on the multi-information display
|
Check vehicle control history
|
|
| Parking assist ECU
|
|
| Clearance warning ECU assembly
|
|
| "Advanced park cannot be used currently" is displayed on the multi-information display
|
Check vehicle control history
|
|
| Parking assist ECU
|
|
| Clearance warning ECU assembly
|
|
| "Remove the dirt" is displayed on the multi-display
|
System determines that images cannot be detected due to dirt on the camera. If dirt is removed, normal control returns
|
-
|
| Check vehicle control history
|
|
| Television camera assembly at the position displayed on the multi-display
|
-
|
| Parking assist ECU
|
|
| Clearance warning ECU assembly
|
|
| Estimated course lines are not displayed.
|
Check advanced park screen (check whether the parking guide lines have been hidden)
|
-
|
| Adjust steering angle
|
|
| Steering sensor
|
|
| Parking assist ECU
|
|
| Assist operation frequently stops and the message "Not available in this environment" is displayed
|
Check tires (tire size, tire pressure, tire wear)
|
-
|
| Check surrounding conditions (no obstacles in front, short path where control is not possible, steps that cannot be driven over)
|
-
|
| Check the setting of the "Road Width Adjustment" on the multi-display settings screen (maximum number of times the tires can be turned)
|
|
| Clearance warning ECU assembly
|
|
| No guidance to the set target parking position
|
Check the setting of the "Parking Path Adjustment" on the multi-display settings screen
|
|
| Proceed to "Vehicle does not Move to Set Parking Position"
|
|
| When setting the target parking position, the initial display position of the target parking lines deviates greatly from the actual parking space (in parallel parking mode
|
Refer to the owner's manual, and after checking the operation conditions, perform the operation again
|
-
|
| Proceed to "Precaution for Ultrasonic Sensor (Parking Space Detection Sensor)"
|
|
| Ultrasonic sensor on target parking position side
|
-
|
| Front bumper assembly
|
|
| Rear bumper assembly
|
|
| Parking assist ECU
|
|
| Clearance warning ECU assembly
|
|