The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hazard warning signal switch removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
58410B
2.REMOVE DECK BOARD ASSEMBLY (for HV Model)
58416K
3.REMOVE REAR NO. 2 FLOOR BOARD (for HV Model)
65351A
4.REMOVE BATTERY HOLE COVER (for HV Model)
5.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for A25A-FKS:
for M20A-FKS:
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55405B
6.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55424C
7.REMOVE RADIO TUNER FINISH PANEL (for Audio-less)
55422C
8.REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL
9.REMOVE STEREO OPENING COVER WITH BRACKET (for Audio-less)
10.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
11.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
12.REMOVE CONSOLE BOX ASSEMBLY
55900
13.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (w/ ECU)
55434B
14.REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
15.REMOVE NAVIGATION ECU WITH BRACKET (w/ ECU, for Navigation System)
16.REMOVE NAVIGATION ECU WITH BRACKET (w/ ECU, for Dummy Case)
17.REMOVE TELEPHONE TRANSCEIVER ASSEMBLY WITH BRACKET (w/ ECU, for Telematics Transceiver)
for LHD:
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
for RHD:
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
84330
18.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY
Place a hand at the rear side of the center register, detach the hazard warning signal switch assembly claw and push towards the rear of the vehicle.
Press the hazard warning signal switch assembly from the top and bottom and detach it.
|
Press in this Direction | - | - |
Disconnect the connector.