The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during refreshing seat switch removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Be sure to read precaution thoroughly before servicing.
for HV Model with Occupant Classification System:
for Gasoline Model with Occupant Classification System:
w/o Occupant Classification System:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
58410B
1.REMOVE DECK BOARD ASSEMBLY (w/ Airbag Cut Off Indicator Light, for HV Model)
58416K
2.REMOVE REAR NO. 2 FLOOR BOARD (w/ Airbag Cut Off Indicator Light, for HV Model)
65351A
3.REMOVE BATTERY HOLE COVER (w/ Airbag Cut Off Indicator Light, for HV Model)
4.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Airbag Cut Off Indicator Light)
for A25A-FKS:
for M20A-FKS:
for A25A-FXS:
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>REMOVAL
for A25B-FXS:
Click hereGeneral>MAINTENANCE>A25B-FXS AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
33504F
5.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
for Automatic Transaxle:
for CVT:
K120:
Click hereDrivetrain>K120 (MULTIDRIVE / CVT)>SHIFT LEVER KNOB>REMOVAL
K120F:
Click hereDrivetrain>K120F (MULTIDRIVE / CVT)>SHIFT LEVER KNOB>REMOVAL
for HV Model:
Click hereDrivetrain>P710 (HYBRID TRANSMISSION / TRANSAXLE)>SHIFT LEVER KNOB>REMOVAL
for Manual Transaxle:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL
58804A
6.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
861C0
7.REMOVE MOBILE WIRELESS CHARGER CRADLE ASSEMBLY (w/ Wireless Charger)
58813
8.REMOVE UPPER CONSOLE BOX (w/o Wireless Charger)
58805C
9.REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
55900
10.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
55434B
11.REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL
84752
12.REMOVE REFRESHING SEAT SWITCH
|
Remove in this Direction |
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw to remove the refreshing seat switch.
Tape the thin-bladed screwdriver tip before use.