Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

MULTIPLEX COMMUNICATION SYSTEM > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


If a malfunction code is displayed during the DTC check, check the circuit listed for that code in the chart below (Proceed to the page given for that circuit).

MULTIPLEX COMMUNICATION SYSTEM 
DTC Code
Detection Item
Trouble Area
See page
B1200
MPX Body ECU Stop
1. Multiplex network body ECU
2. Wire harness
Click here
B1208
Passenger Side Outer Mirror ECU
1. Outer mirror control ECU RH
2. Wire harness
Click here
B1209
Driver Side Outer Mirror
1. Outer mirror control ECU LH
2. Wire harness
Click here
B1214
Short to B+ in Door System Communication Bus Malfunction
1. Multiplex network gateway ECU
2. Multiplex network body ECU
3. Airbag sensor assembly
4. A/C amplifier
5. Combination meter
6. Power slide door ECU LH
7. Power slide door ECU RH
8. Power back door ECU
9. Seat position control ECU
10. Outer mirror control ECU LH 11. Outer mirror control ECU RH
12. Wire harness
Click here
B1215
Short to GND in Door System Communication Bus Malfunction
1. Multiplex network gateway ECU
2. Multiplex network body ECU
3. Airbag sensor assembly
4. A/C amplifier
5. Combination meter
6. Power slide door ECU LH
7. Power slide door ECU RH
8. Power back door ECU
9. Seat position control ECU
10. Outer mirror control ECU LH 11. Outer mirror control ECU RH
12. Wire harness
Click here
B1216
Rear Door ECU RH Communication Stop
1. Power slide door ECU RH
2. Wire harness
Click here
B1217
Rear Door ECU LH Communication Stop
1. Power slide door ECU LH
2. Wire harness
Click here
B1262
A/C ECU Communication Stop
1. A/C amplifier
2. Wire harness
Click here
B1271
Combination Meter ECU Communication Stop
1. Combination meter
2. Wire harness
Click here
B1272
Power Seat ECU Communication Stop
1. Seat position control ECU
2. Wire harness
Click here
B1281
Airbag ECU Communication Stop
1. Airbag sensor assembly
2. Wire harness
Click here
B1287
Back Door ECU Communication Stop
1. Power back door ECU
2. Wire harness
Click here

HINT:
When DTCs indicating "+B or GND short malfunction of communication bus" (B1214, B1215) are detected at the same time as DTCs indicating "communication stop" (B1200, B1208, etc.), repair DTCs indicating "+B or GND short malfunction of communication bus" first.