Home › Engine / Hybrid System › B48 (ENGINE MECHANICAL) › ENGINE WIRE HARNESS (for No. 1)
RM3650E _51 Engine / Hybrid System _080178 B48 ENGINE MECHANICAL _0388850 ENGINE WIRE HARNESS(for No. 1) A

B48 ENGINE MECHANICAL  ENGINE WIRE HARNESS(for No. 1)  INSTALLATION  


PROCEDURE

Hide 82121 1.INSTALL ENGINE WIRE

a.

Overview: Engine wire

NOTICE:
·

Improper routing of cables and wiring harnesses.

Trapped, crushed or damaged cables may cause short circuits and malfunctions.

-

Route all cables without abrasions, do not trap and crush.




A445565


b.
A441491

Thread in and install the engine wire (1).


c.

Secure all clamps.


d.

Connect and lock the connector for the crankshaft position sensor.


e.

Connect and lock the connector for the oil pressure sensor.


f.

Connect and lock the connector for the oil pressure control valve assembly.


g.

Connect and lock the connectors for the knock sensors.


h.

Connect and lock the connector for the engine coolant temperature sensor (for Engine).


i.

Connect and lock the connector for the engine oil level sensor.

i.

The connectors must engage audibly.



j.
A441490

Connect and lock the connector for the generator assembly.


k.

Connect and lock the connector for the compressor with magnet clutch.


l.

Connect and lock the connector of the water pump assembly (for Turbo).


m.

Connect and lock the connector for the water valve.


n.

Connect and lock the connector of the vacuum sensor assembly.


o.

Connect and lock the connector of the air pressure sensor.


p.

Connect and lock the connector of the No. 4 fuel vapor feed hose.


q.

Connect and lock the connector for the throttle body with motor assembly.


r.

Connect and lock the connector for the inlet air temperature sensor.

i.

The connectors must engage audibly.



Hide 23285A 3.INSTALL NO. 1 CHECK VALVE

Hide 11401T 6.INSTALL CYLINDER BLOCK COVER

Hide 11271A 8.INSTALL REAR CYLINDER BLOCK COVER

Hide 55788A 9.INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 85010 10.INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY

Hide 17880 11.INSTALL AIR CLEANER HOSE ASSEMBLY

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 14.ADD ENGINE COOLANT (for Low Temperature)

Hide 12140 15.INSTALL OIL PAN COVER

Hide 51219 16.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 12601B 17.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY