1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67914
3.REMOVE FRONT DOOR SCUFF PLATE LH
for Regular Cab:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Regular Cab)>REMOVAL)
for Double Cab:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Double Cab)>REMOVAL)
for CrewMax:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for CrewMax)>REMOVAL)
62112
4.REMOVE COWL SIDE TRIM BOARD LH
for Regular Cab:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Regular Cab)>REMOVAL)
for Double Cab:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for Double Cab)>REMOVAL)
for CrewMax:
(See page Vehicle Interior>INTERIOR>ROOF HEADLINING(for CrewMax)>REMOVAL)
55318C
5.REMOVE INSTRUMENT SIDE PANEL LH
for Column Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Column Shift Type)>REMOVAL)
for Floor Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Floor Shift Type)>REMOVAL)
55046A
6.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH
for Column Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Column Shift Type)>REMOVAL)
for Floor Shift Type:
(See page Vehicle Interior>INTERIOR PANEL>INSTRUMENT PANEL SAFETY PAD(for Floor Shift Type)>INSTALLATION)
73900
7.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
8.REMOVE GLASS BREAKAGE SENSOR ECU
Disconnect each connector.
Remove the 2 nuts and junction block.
Remove the nut and glass breakage sensor ECU.