When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly may not operate normally.
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
*1: w/ Blind Spot Monitor System
*2: for Gasoline Model
*3: for HV Model
*4: for Gasoline Model TMC Made RHD
*5: for Gasoline Model TMMF Made RHD
*6: for Gasoline Model TMMF, TMMCZ Made LHD
*7: for HV Model TMC Made RHD
*8: for HV Model TMMF Made RHD
*9: for HV Model LHD