42116
1.INSTALL REAR AXLE BEAM COVER
Install the cover with the 2 bolts.
Perform the procedure above on the other side.
57794
2.INSTALL REAR NO. 1 SUSPENSION ARM BRACKET REAR LH
Install the bracket with the 2 bolts.
57793
3.INSTALL REAR NO. 1 SUSPENSION ARM BRACKET REAR RH
Use the same procedures described for the LH side.
42110F
4.INSTALL REAR AXLE BEAM ASSEMBLY
Slowly raise the rear axle beam with a jack, and install the axle beam to the body with the 2 bolts and 2 nuts.
48258C
5.INSTALL REAR COIL SPRING INSULATOR LOWER LH
48258B
6.INSTALL REAR COIL SPRING INSULATOR LOWER RH
Use the same procedures described for the LH side.
48231B
7.INSTALL REAR COIL SPRING LH
48231A
8.INSTALL REAR COIL SPRING RH
Use the same procedures described for the LH side.
48259A
9.INSTALL REAR COIL SPRING INSULATOR UPPER LH
48257C
10.INSTALL REAR COIL SPRING INSULATOR UPPER RH
Use the same procedures described for the LH side.
48540
11.INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
48530
12.INSTALL REAR SHOCK ABSORBER ASSEMBLY RH
Use the same procedures described for the LH side.
89408C
13.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH
14.INSTALL PARKING BRAKE ASSEMBLY LH
Install the parking brake to the axle beam.
15.INSTALL PARKING BRAKE ASSEMBLY RH
Use the same procedures described for the LH side.
42450B
16.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH
42450A
17.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY RH
Use the same procedures described for the LH side.
89516
18.INSTALL SKID CONTROL SENSOR WIRE
46430
19.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
46420
20.INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY
42431
21.INSTALL REAR DISC
22.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
23.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY RH
Use the same procedures described for the LH side.
17430
24.INSTALL TAIL PIPE ASSEMBLY (for 2AZ-FE)
17430
25.INSTALL TAIL PIPE ASSEMBLY (for 2GR-FE)
26.INSTALL REAR WHEEL
27.STABILIZE SUSPENSION
28.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
Inspect and adjust the rear wheel alignment (See page Suspension>SUSPENSION>REAR WHEEL ALIGNMENT>ADJUSTMENT).
29.CHECK SPEED SENSOR SIGNAL