2011-2013 Land Cruiser · Service Manual Brake

C1337/37 Diameter of the Tire is not Uniform

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The skid control ECU measures the speed of each wheel by receiving signals from the speed sensor. These signals are used for recognizing that all 4 wheels are operating properly. Therefore, all wheel signals must be equal.
DTC Code
DTC Detection Condition
Trouble Area
C1337/37
When either of the following conditions is detected:
  1. The diameter is different between the 2 front wheels and the 2 rear wheels.
  2. There is a wheel speed sensor fault.
  1. Speed sensor
  2. Speed sensor rotor
  3. Speed sensor circuit
  4. Tire size

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK TIRE SIZE
  1. Check tire size and condition of all 4 wheels.

    OK:
    Condition of all 4 wheels is normal and tire size is same.



NG
REPLACE TIRES SO THAT ALL 4 TIRES ARE SAME SIZE
OK


2. INSPECT SPEED SENSOR ROTOR
  1. Check the front speed sensor rotors (Click here) and rear speed sensor rotors (Click here).

    Result 
    Result
    Proceed to
    OK
    A
    NG
    Front speed sensor
    B
    Rear speed sensor
    C



B
REPLACE FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY (SPEED SENSOR ROTOR) (Click here)

C
REPLACE REAR AXLE HUB AND BEARING ASSEMBLY (SPEED SENSOR ROTOR) (Click here)
A


3. INSPECT SPEED SENSOR
  1. Check the front speed sensor circuit (Click here) and rear speed sensor circuit (Click here).

    Result 
    Result
    Proceed to
    OK
    A
    NG
    Front speed sensor
    B
    Rear speed sensor
    C



B
REPLACE FRONT SPEED SENSOR (Click here)

C
REPLACE REAR SPEED SENSOR (Click here)
A


4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - SPEED SENSOR)
  1. Check the front speed sensor circuit (Click here) and rear speed sensor circuit (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Drive the vehicle at a speed of approximately 32 km/h (20 mph) or more for 60 seconds or more.

  1. Check if the same DTCs are output (Click here).

    HINT:
    Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    LHD
    B
    RHD
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1337 Diameter of the Tire is not Uniform (from Jan 2012)C1401 Front Speed Sensor RH Malfunction (+ C1271, C1272, C1402) (from Jan 2012) →