Home › General › MAINTENANCE › ENGINE › 2014.08–2016.08
RM25T0E _V1 General _029889 MAINTENANCE _0140195 ENGINE N

MAINTENANCE  ENGINE  GENERAL MAINTENANCE  


CAUTION / NOTICE / HINT

HINT:

Perform these procedures after the engine has cooled down.


PROCEDURE

Hide 1.REPLACE TIMING BELT (for 1HZ)

a.

Replace the timing belt.

Type See procedure
1HZ (Click here)


Hide 2.INSPECT VALVE CLEARANCE (for 1GR-FE, 1HZ)

a.

Inspect the valve clearance.

Type See procedure
1GR-FE (Click here)
1HZ (Click here)


Hide 3.INSPECT DRIVE BELT

a.

Inspect the drive belt.

Type See procedure
1GR-FE (Click here)
1HZ (Click here)
1VD-FTV (Click here)


Hide 4.REPLACE ENGINE OIL AND OIL FILTER

a.

Replace the engine oil and filter.

Type See procedure
1GR-FE (Click here)
1HZ (Click here)
1VD-FTV (Click here)


Hide 5.INSPECT COOLING AND HEATER SYSTEM

a.

Check that the radiator, condenser and/or intercooler is not blocked with leaves, dirt or insects, and clean them if necessary. Also check the hose connection for the installation condition, corrosion, etc.


Hide 6.INSPECT ENGINE COOLANT

a.

Inspect the engine coolant.

Type See procedure
1GR-FE (Click here)
1HZ (Click here)
1VD-FTV (Click here)


Hide 7.REPLACE ENGINE COOLANT

a.

Replace the engine coolant.

Type See procedure
1GR-FE (Click here)
1HZ (Click here)
1VD-FTV (Click here)


Hide 8.INSPECT OIL COOLER HOSE AND CONNECTIONS (for 1GR-FE)

a.

Check the oil cooler hoses for cracks, leakage, loose connections and deformation.


Hide 9.INSPECT EXHAUST PIPES AND MOUNTINGS

a.

Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.


Hide 10.REPLACE SPARK PLUGS

a.

Replace the spark plugs.

Type See procedure
1GR-FE (Click here)


Hide 11.INSPECT BATTERY ELECTROLYTE LEVEL

a.

Inspect the battery electrolyte level.

Type See procedure
1GR-FE (Click here)
1HZ (Click here)
1VD-FTV (Click here)


Hide 12.REPLACE FUEL FILTER (for 1GR-FE, 1HZ)

a.

Replace the fuel filter.

Type See procedure
1GR-FE (Click here)
1HZ (Click here)


Hide 13.INSPECT WATER SEDIMENT ACCUMULATOR (for 1HZ, 1VD-FTV)

a.

Inspect the water sediment accumulator.

Type See procedure
1HZ (Click here)
1VD-FTV (Click here)


Hide 14.INSPECT AIR CLEANER FILTER

a.

Remove the air cleaner filter.


b.

Visually check that the air cleaner filter is not excessively damaged or oily. If necessary, replace the air cleaner filter with a new one.


c.

If cleaning an air cleaner filter element, blow compressed air to clean it.


d.

Reinstall the air cleaner filter.


Hide 15.INSPECT AIR CLEANER CASE

a.

Check if foreign matter has accumulated in the bottom of the air cleaner case. If foreign matter has accumulated in the bottom of the air cleaner case, clean the air cleaner case.

NOTICE:

When cleaning the air cleaner case, prevent any foreign matter from entering into the engine.



Hide 16.INSPECT IDLE SPEED (for 1HZ)

a.

Inspect the idle speed.

Type See procedure
1HZ (Click here)


Hide 17.INSPECT FUEL TANK CAP GASKET

a.

Inspect the fuel tank cap gasket.

Type See procedure
1GR-FE (Click here)
1HZ (Click here)
1VD-FTV (Click here)


Hide 18.INSPECT FUEL LINES, FUEL LINE CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BAND

a.

Visually check the fuel lines and hoses for cracks, leakage, loose connections and deformation. Also, visually check the tank band for looseness.


Hide 19.INSPECT CHARCOAL CANISTER (for 1GR-FE)

a.

Inspect the charcoal canister.

Type See procedure
1GR-FE (Click here)