Perform these procedures after the engine has cooled down.
2.INSPECT VALVE CLEARANCE (for 1GR-FE, 1HZ)
4.REPLACE ENGINE OIL AND OIL FILTER
5.INSPECT COOLING AND HEATER SYSTEM
Check that the radiator, condenser and/or intercooler is not blocked with leaves, dirt or insects, and clean them if necessary. Also check the hose connection for the installation condition, corrosion, etc.
6.INSPECT ENGINE COOLANT
7.REPLACE ENGINE COOLANT
8.INSPECT OIL COOLER HOSE AND CONNECTIONS (for 1GR-FE)
Check the oil cooler hoses for cracks, leakage, loose connections and deformation.
9.INSPECT EXHAUST PIPES AND MOUNTINGS
Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
10.REPLACE DPR HOSE (w/ DPF)
Replace the DPR hoses (No. 1 air hose and No. 2 air hose).
Click hereEngine / Hybrid System>1VD-FTV (EMISSION CONTROL)>DIFFERENTIAL PRESSURE SENSOR(for DPF)>REMOVAL
12.INSPECT BATTERY ELECTROLYTE LEVEL
13.REPLACE FUEL FILTER (for 1GR-FE, 1HZ)
14.INSPECT WATER SEDIMENT ACCUMULATOR (for 1HZ, 1VD-FTV)
15.INSPECT AIR CLEANER FILTER
Remove the air cleaner filter.
Visually check that the air cleaner filter is not excessively damaged or oily. If necessary, replace the air cleaner filter with a new one.
If cleaning an air cleaner filter element, blow compressed air to clean it.
Reinstall the air cleaner filter.
16.INSPECT AIR CLEANER CASE
Check if foreign matter has accumulated in the bottom of the air cleaner case. If foreign matter has accumulated in the bottom of the air cleaner case, clean the air cleaner case.
When cleaning the air cleaner case, prevent any foreign matter from entering into the engine.
18.INSPECT FUEL TANK CAP GASKET
19.INSPECT FUEL LINES, FUEL LINE CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BAND
Visually check the fuel lines and hoses for cracks, leakage, loose connections and deformation. Also, visually check the tank band for looseness.