Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2016.08
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0135612 ANTI-LOCK BRAKE SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:

When replacing the brake actuator assembly, sensor, etc., turn the ignition switch off.


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Anti-lock Brake System
Symptom Suspected Area See page
ABS does not operate Check for DTCs again and make sure that the normal system code is output. (Click here)
IG power source circuit (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Check brake actuator assembly operation using the Active Test function. If abnormal, check the hydraulic circuit for leaks. (Click here)
If the symptoms still occur even after the above items have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). (Click here)
ABS does not operate efficiently Check for DTCs again and make sure that the normal system code is output. (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Stop light switch circuit (Click here)
Check brake actuator assembly operation using the Active Test function. If abnormal, check the hydraulic circuit for leaks. (Click here)
If the symptoms still occur even after the above items have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). (Click here)
ABS sensor DTC check cannot be done Check for DTCs again and make sure that the normal system code is output. (Click here)
TC and CG terminal circuit (Click here)
ABS warning light abnormal (Remains on) Refer to ABS Warning Light Remains ON (Click here)
ABS warning light abnormal (Does not come on) Refer to ABS Warning Light does not Come ON (Click here)
Brake warning light abnormal (Remains on) Refer to Brake Warning Light Remains ON (Click here)
Brake warning light abnormal (Does not come on) Refer to Brake Warning Light does not Come ON (Click here)
Test Mode (signal check) cannot be done TS and CG terminal circuit (Click here)