Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › ELECTRONIC SHIFT LEVER SYSTEM

ELECTRONIC SHIFT LEVER SYSTEM > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


If a trouble code is displayed during the DTC check, check the circuit listed for that code in the table below and proceed to the appropriate page.

HINT:
  1. When the DTC C2300, C2301, C2304, C2305, C2306, C2307, C2311 and C2312 are detected, DTC P3102 indicating the electronic shift lever system malfunctions are detected for the hybrid system as well. Because of this, the hybrid system DTCs must be cleared after clearing the electronic shift lever system DTCs.
  2. Remove the P CON MAIN fuse to erase DTCs C2300, C2301, C2303, C2304, C2305, C2306 and C2307 because they cannot be erased with the Techstream.
  3. When a DTC is detected, the master warning light comes on and an error message is indicated on the multi-display.
  4. The indicator blinks quickly when it takes a long time to switch between the P position status and the P position release status.


 
DTC Code
Detection Item
Trouble Area
P Position Switch Indicator Light Condition
HINT
See page
C2300
ACT System Malfunction
- Shift control actuator
- Transaxle parking lock control relay
- Transmission control ECU
- Wire harness or connector
Blinks slowly
If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first.
Click here
C2301
Shift Changing Time Malfunction
- Shift control actuator
- Transmission control ECU
Blinks slowly
If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first.
Click here
C2303
Relay Malfunction (+B Short)
- Transaxle parking lock control relay
- Transmission control ECU
- Wire harness or connector
Normal
- P position status: the P position switch indicator light is on.
- P position release status: the P position switch indicator light is off.
If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first.
Click here
C2304
Open or Short Circuit in "U" Phase
- Shift control actuator
- Transmission control ECU
- Transaxle parking lock control relay
- Wire harness or connector
Blinks slowly
If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first.
Click here
C2305
Open or Short Circuit in "V" Phase
- Shift control actuator
- Transmission control ECU
- Transaxle parking lock control relay
- Wire harness or connector
Blinks slowly
If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first.
Click here
C2306
Open or Short Circuit in "W" Phase
- Shift control actuator
- Transmission control ECU
- Transaxle parking lock control relay
- Wire harness or connector
Blinks slowly
If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first.
Click here
C2307
Power Source Malfunction
- Transmission control ECU
- Wire harness or connector
- Parking lock motor (Shift control actuator)
Blinks slowly
If DTC C2318 is output simultaneously, perform troubleshooting for DTC C2318 first.
Click here
C2310
Open or Short Circuit in BATT
- P CON MAIN fuse
- Transmission control ECU
- Wire harness or connector
Normal
- P position status: the P position switch indicator light is on.
- P position release status: the P position switch indicator light is off.
-
Click here
C2311
HV Communication Line Malfunction
- Transmission control ECU
- Hybrid vehicle control ECU
- Wire harness or connector
Blinks slowly
-
Click here
C2312
Power Source Control ECU Communication Line Malfunction
- Transmission control ECU
- Power source control ECU
Normal
- P position status: the P position switch indicator light is on.
- P position release status: the P position switch indicator light is off.
-
Click here
C2315
HV System Malfunction
- Hybrid vehicle control ECU
- P position switch
- Transmission control ECU
- Wire harness or connector
Normal
- P position status: the P position switch indicator light is on.
- P position release status: the P position switch indicator light is off.
-
Click here
C2318
Low Voltage Error (Power Supply Malfunction)
- HEV fuse
- IGCT relay
- Wire harness or connector
- Auxiliary battery
Normal
- P position status: the P position switch indicator light is on.
- P position release status: the P position switch indicator light is off.
-
Click here