Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM
RM27L0U _57 Power Source / Network _049335 NETWORKING _0235802 CAN COMMUNICATION SYSTEM S

NETWORKING  CAN COMMUNICATION SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


HINT:

If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.


CAN Communication System
DTC Code Detection Item DTC Output from See page
B2621 Communication Interruption Multiplex tilt and telescopic ECU (Click here)
B2624 Vehicles Speed Malfunction Multiplex tilt and telescopic ECU (Click here)
U0104 Lost Communication with Driving Support ECU Network gateway ECU (Click here)
U0199 Lost Communication with "Door Control Module A" Main body ECU (cowl side junction block LH) (Click here)
U0208 Lost Communication with "Seat Control Module A" Main body ECU (cowl side junction block LH) (Click here)
U0230 Lost Communication with Rear Gate Module Main body ECU (cowl side junction block LH) (Click here)
U0232 Lost Communication with Blind Spot Monitor Slave Module - Network gateway ECU
- Blind spot monitor sensor LH
(Click here)
U0233 Lost Communication with Blind Spot Monitor Master Module - Network gateway ECU
- Blind spot monitor sensor RH
(Click here)
U1002 Lost Communication with Gateway Module Main body ECU (cowl side junction block LH) (Click here)
U1002 (CAN No. 2 BUS) Lost Communication with Gateway Module (Network Gateway ECU) Network gateway ECU (Click here)
U1115 Lost Communication with Tilt and Telescopic Module Main body ECU (cowl side junction block LH) (Click here)