Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here



 
Symptom
Suspected area
See page
Main switch cannot be turned ON (Indicator light on the combination meter does not come on)
1. Cruise control switch circuit
Click here
2. CRUISE MAIN indicator light circuit
Click here
3. ECM (1GR-FE)
Click here
3. ECM (2TR-FE)
Click here
Desired speed cannot be set (Indicator light on the combination meter comes on when the main switch is turned ON, but goes off when operating the "SET" function)
1. Cruise control switch circuit
Click here
2. ECM (1GR-FE)
Click here
2. ECM (2TR-FE)
Click here
Desired speed cannot be set (Indicator light on the combination comes on when the main switch is turned ON and it remains ON, while operating the "SET" function)
1. Cruise control switch circuit
Click here
2. Stop light switch circuit
Click here
3. Clutch switch circuit (M/T)
Click here
3. Park/neutral position switch circuit (A/T: 1GR-FE)
Click here
3. Park/neutral position switch circuit (A/T: 2TR-FE)
Click here
4. Combination meter system
Click here
5. ECM (1GR-FE)
Click here
5. ECM (2TR-FE)
Click here
While cruise control driving, the set speed is canceled (Indicator light remains ON)
1. Cruise control switch circuit
Click here
2. Vehicle speed sensor circuit (1GR-FE)
Click here
2. Vehicle speed sensor circuit (2TR-FE)
Click here
3. Stop light switch circuit
Click here
4. CRUISE MAIN indicator light circuit
Click here
5. Clutch switch circuit (M/T)
Click here
5. Park/neutral position switch circuit (A/T: 1GR-FE)
Click here
5. Park/neutral position switch circuit (A/T: 2TG-FE)
Click here
6. ECM (1GR-FE)
Click here
6. ECM (2TR-FE)
Click here
Hunting occurs (Speed is not constant)
1. Vehicle speed sensor circuit (1GR-FE)
Click here
1. Vehicle speed sensor circuit (2TR-FE)
Click here
2. ECM (1GR-FE)
Click here
2. ECM (2TR-FE)
Click here
Speed setting cannot be canceled ("CANCEL" function failure only)
1. Cruise control switch circuit
Click here
2. ECM (1GR-FE)
Click here
2. ECM (2TR-FE)
Click here
DTC is not output, or is output when should not be
1. DLC3 circuit
Click here
2. ECM (1GR-FE)
Click here
3. ECM (2TR-FE)
Click here
CRUISE MAIN indicator light does not come on
1. Cruise control switch circuit
Click here
2. CRUISE MAIN indicator light circuit
Click here
3. ECM (1GR-FE)
Click here
3. ECM (2TR-FE)
Click here
4. Combination meter assembly
Click here