| ● | Non-reusable part | - | - |
| ● | Non-reusable part | ★ | Precoated part |
| ● | Non-reusable part | ★ | Precoated part |
| *A | w/ Stud Bolt | *B | w/o Stud Bolt |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cylinder head gasket removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.INSTALL ENGINE ASSEMBLY TO ENGINE STAND
2.REMOVE ENGINE HANGERS
22030
6.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
23250
7.REMOVE FUEL INJECTOR ASSEMBLY
11.REMOVE WATER BY-PASS PIPE ASSEMBLY
16281
12.REMOVE NO.4 WATER BY-PASS HOSE
12262
13.REMOVE NO.2 VENTILATION HOSE
12315A
21.REMOVE ENGINE MOUNTING BRACKET RH
13519
24.REMOVE OIL PUMP DRIVE GEAR
13506
27.REMOVE CHAIN SUB-ASSEMBLY
13521
28.REMOVE CRANKSHAFT TIMING GEAR OR SPROCKET
13540
29.REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY
13559
30.REMOVE CHAIN TENSIONER SLIPPER
13561
31.REMOVE NO. 1 CHAIN VIBRATION DAMPER
13478
34.REMOVE CRANKSHAFT PULLEY SPACER
13501A
37.REMOVE INTAKE CAMSHAFT SUB-ASSEMBLY
13502B
38.REMOVE EXHAUST CAMSHAFT SUB-ASSEMBLY
11115
40.REMOVE CYLINDER HEAD GASKET