| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | CYLINDER HEAD GASKET | 11115 | ( )
|
- | - |
| 2 | CYLINDER HEAD SUB-ASSEMBLY | 11101 | ( )
|
- | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
| *T1 | 1st: 50 (510, 37)
2nd: Turn 90° 3rd: Turn 90° |
- | - |
| *A | w/ Stud Bolt | *B | w/o Stud Bolt |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | ★ | Precoated part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 26 | CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY | 13090D | ( )
|
- | - |
| 27 | CAM TIMING OIL CONTROL SOLENOID ASSEMBLY | 15370 | ( )
|
- | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| ★ | Precoated part | - | - |
| *A | w/ Differential Pressure Sensor | *B | w/o Differential Pressure Sensor |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| * | For use union nut wrench |
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
11115
1.INSTALL CYLINDER HEAD GASKET
| *a | Lot No. | - | - |
|
Front of Engine | - | - |
Place a new cylinder head gasket on the cylinder block sub-assembly with the Lot No. stamp facing upward.
Clean the cylinder block sub-assembly and cylinder head sub-assembly with solvent.
Make sure that the cylinder head gasket is installed in the correct orientation.
13478
7.INSTALL CRANKSHAFT PULLEY SPACER
13561
11.INSTALL NO. 1 CHAIN VIBRATION DAMPER
13559
12.INSTALL CHAIN TENSIONER SLIPPER
13521
14.INSTALL CRANKSHAFT TIMING GEAR OR SPROCKET
13506
15.INSTALL CHAIN SUB-ASSEMBLY
13519
18.INSTALL OIL PUMP DRIVE GEAR
12315A
21.INSTALL ENGINE MOUNTING BRACKET RH
11102A
23.INSTALL CAMSHAFT POSITION SENSOR
12262
28.INSTALL NO. 2 VENTILATION HOSE
16281
29.INSTALL NO. 4 WATER BY-PASS HOSE
30.INSTALL WATER BY-PASS PIPE ASSEMBLY
23250
34.INSTALL FUEL INJECTOR ASSEMBLY
25733A
39.INSTALL NO. 1 VACUUM PIPE (w/ Differential Pressure Sensor)
25760
40.INSTALL VACUUM TRANSMITTING HOSE ASSEMBLY (w/ Differential Pressure Sensor)
41.INSTALL ENGINE HANGERS