ENG A-STOP System Symptom Diagnosis
Precautions: Precautions for Diagnosing Trouble · Precautions for Servicing ENG A-STOP System · Precautions for Replacing ENG A-STOP Control Module · Precautions for Control Systems · General safety (00)
NOTE:
•Perform ENG A-STOP system check referring to ENG A-STOP System Check before performing this ENG A-STOP System Symptom Diagnosis.
•ENG A-STOP control module monitors the battery condition through input signals from the battery voltage and electric load current sensor & battery temperature sensor, etc., and performs the ENG A-STOP control only when it judges that the battery is in a fully charged condition.
•In case the battery discharge is suspected (e.g. when the vehicle has not been used for a long time.), disconnect the negative (–) cable at the battery and recharge the battery.
When recharging the battery without disconnecting the negative (–) cable at the battery, it will be necessary to drive the for maximum 3 hours before the ENG A-STOP control module judges that the battery is fully charged, during which the ENG A-STOP system does not operate.
•ENG A-STOP control module monitors the battery condition through input signals from the battery voltage and electric load current sensor & battery temperature sensor, etc., and performs the ENG A-STOP control only when it judges that the battery is in a fully charged condition.
•In case the battery discharge is suspected (e.g. when the vehicle has not been used for a long time.), disconnect the negative (–) cable at the battery and recharge the battery.
When recharging the battery without disconnecting the negative (–) cable at the battery, it will be necessary to drive the for maximum 3 hours before the ENG A-STOP control module judges that the battery is fully charged, during which the ENG A-STOP system does not operate.
| Condition | Possible Cause | Action |
|---|---|---|
|
Engine auto start control does not operate
|
Lighting or blinking MIL
|
Check DTC.
|
|
Faulty CPP switch (M/T model)
|
Check CPP switch.
|
|
|
Faulty starting motor
|
||
|
Faulty engine system
|
Check engine.
|
|
|
Faulty neutral position switch (M/T model)
|
||
|
Faulty hood latch switch
|
||
|
Faulty electric load current sensor & battery temperature sensor
|
||
|
Faulty brake booster pressure sensor
|
||
|
Faulty brake booster
|
||
|
Faulty ECM
|
Check ECM and its circuit.
|
|
|
Faulty ESP® system
|
||
|
Faulty HVAC control module (auto A/C model)
|
||
|
Faulty ENG A-STOP control module
|
||
|
Engine auto stop control does not operate
|
Lighting or blinking MIL
|
Check DTC.
|
|
Faulty CPP switch (M/T model)
|
Check CPP switch.
|
|
|
Faulty G sensor
|
||
|
Faulty ENG A-STOP OFF switch
|
||
|
Faulty neutral position switch (M/T model)
|
||
|
Faulty brake light switch (A/T model / twin clutch system model)
|
||
|
Faulty G sensor (A/T model / twin clutch system model)
|
||
|
Faulty brake master cylinder pressure sensor (A/T model / twin clutch system model)
|
||
|
Faulty APP sensor (A/T model / twin clutch system model)
|
Check APP sensor.
|
|
|
Faulty driver door switch
|
||
|
Faulty driver seat belt buckle switch
|
||
|
Faulty generator
|
Check charging system.
|
|
|
Faulty ECT sensor
|
Check ECT sensor.
|
|
|
Faulty throttle body (M16A model / K14C model)
|
Check throttle body.
|
|
|
Faulty battery
|
Check battery.
|
|
|
Faulty HVAC control module (auto A/C model)
|
||
|
Faulty ECM
|
Check ECM and its circuit.
|
|
|
Faulty ESP® system
|
||
|
Faulty twin clutch system (twin clutch system model)
|
||
|
Faulty ENG A-STOP control module
|