1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
Before installing the transmission control cable assembly, check that the park/neutral position switch and shift lever are in neutral.
Put the transmission control cable into the cabin and connect the transmission control cable with the 2 bolts.
Connect the transmission control cable clamp with the 2 nuts.
Install the transmission control cable assembly to the bracket with a new clip.
Install the transmission control cable assembly to the control shaft lever with the nut.
Connect the transmission control cable to the control cable clamp bracket.
Turn the nut of the transmission control cable 180° counterclockwise. While holding the nut in place, push in the stopper until it clicks twice.
| *1 | Stopper | *2 | Nut |
| *a | Push in | - | - |
Install the outer part of the transmission control cable to the shift lever retainer. Check that the spring is positioned at "A" and push in the stopper.
| *1 | Stopper | *2 | Nut |
| *3 | Shift Lever Retainer | *4 | Spring |
If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.
Push the 2 claws together at the top of the transmission control cable lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to pull out the lock piece.
| *1 | Lock Piece |
| *a | Side View |
| *b | Bottom View |
| *c | Push |
Connect the end of the cable to the shift lever assembly.
Make sure that the lock piece is pulled up.
Push the end of the cable all the way to the base of the pin.
| *1 | Lock Piece |
Push the lock piece into the adjuster case.
| *1 | Lock Piece |
| *2 | Adjuster Case |
| *a | Push in |
Securely push in the lock piece until it locks.
55434B
2.INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER
58533C
3.INSTALL FLOOR CARPET COVER CENTER RH
58534E
4.INSTALL FLOOR CARPET COVER CENTER LH
55432B
5.INSTALL INSTRUMENT PANEL FINISH PANEL LOWER (w/ Knee Airbag)
55432B
6.INSTALL INSTRUMENT PANEL FINISH PANEL LOWER (w/o Knee Airbag)
55606
7.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62111C
8.INSTALL COWL SIDE TRIM BOARD RH
67913B
9.INSTALL FRONT DOOR SCUFF PLATE RH
55447C
10.INSTALL NO. 1 SWITCH HOLE BASE
55474B
11.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH
55607
12.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62112
13.INSTALL COWL SIDE TRIM BOARD LH
67914B
14.INSTALL FRONT DOOR SCUFF PLATE LH
55550
15.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
55041B
16.INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
55660
17.INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
55042B
18.INSTALL NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY
55650
19.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
20.INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)
55414A
21.INSTALL INSTRUMENT CLUSTER FINISH PANEL END (w/o Navigation System)
55420A
22.INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY
23.INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE
45286
24.INSTALL STEERING COLUMN COVER
45100
25.INSTALL STEERING WHEEL ASSEMBLY
45130
26.INSTALL STEERING PAD ASSEMBLY
45186
27.INSTALL NO. 2 STEERING WHEEL LOWER COVER
45187
28.INSTALL NO. 3 STEERING WHEEL LOWER COVER
74414D
29.INSTALL BATTERY CARRIER SUPPORT
74411
30.INSTALL BATTERY CARRIER
17752
31.INSTALL NO. 2 AIR CLEANER INLET
17751
32.INSTALL NO. 1 AIR CLEANER INLET
17700
33.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17705
34.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
35.INSTALL BATTERY
55712
36.INSTALL FRONT COWL TOP OUTSIDE PANEL WITH WINDSHIELD WIPER MOTOR AND LINK
16611
37.INSTALL RADIATOR RESERVOIR BRACKET
16470
38.INSTALL RADIATOR RESERVOIR ASSEMBLY
39.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
40.INSPECT SHIFT LEVER POSITION
41.ADJUST SHIFT LEVER POSITION