Home › Drivetrain › H150F (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSMISSION ASSEMBLY › 2014.08–2015.08
RM2660E _52 Drivetrain _052809 H150F MANUAL TRANSMISSION / TRANSAXLE _0255320 MANUAL TRANSMISSION ASSEMBLY A

H150F MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 58280A 4.REMOVE SHIFT LEVER BOOT ASSEMBLY

C172726

a.

Remove the 4 screws, shift lever retainer and shift lever boot.


Hide 33530F 5.REMOVE FLOOR SHIFT LEVER ASSEMBLY

C176506E02
0.802,0.948 0.708,0.396 false 0.708,0.396 0.552,0.396 false 2.406,0.146 2.854,0.333 0.448,0.188 10 false Down 1.302,1.771 2.521,2.115 1.219,0.344 10 true Counterclockwise 0.104,0.302 0.521,0.469 0.417,0.167 10 false Cloth

a.

Cover the shift lever cap with a cloth.


b.

Press down on the shift lever cap and rotate it counterclockwise to remove it.


c.

Pull out the shift lever.


Hide 12601E 6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Intercooler)

Hide 17940D 7.REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)

Hide 17972 8.REMOVE NO. 2 COOL AIR INLET (w/o Intercooler)

Hide 9.DRAIN CLUTCH FLUID

Hide 17972 11.REMOVE AIR TUBE SUB-ASSEMBLY LH (for 1VD-FTV)

Hide 31489 12.REMOVE TUBE CONNECTOR TO FLEXIBLE HOSE TUBE (for 1VD-FTV)

Hide 33183 14.REMOVE TRANSFER DYNAMIC DAMPER (for 1VD-FTV)

C173746

a.

Remove the 2 bolts and transfer dynamic damper.


Hide 36179 15.REMOVE LOWER TRANSFER CASE PROTECTOR

C173748

a.

Remove the 7 bolts and lower transfer case protector.


Hide 37110 18.REMOVE PROPELLER SHAFT ASSEMBLY

Hide 37140 19.REMOVE FRONT PROPELLER SHAFT ASSEMBLY

Hide 17420 20.REMOVE EXHAUST PIPE (for 1GR-FE)

Hide 17119 23.REMOVE NO. 2 MANIFOLD STAY (for 1GR-FE)

Hide 28100 24.REMOVE STARTER ASSEMBLY (for 1GR-FE)

Hide 51203 25.REMOVE NO. 2 FRAME CROSSMEMBER SUB-ASSEMBLY

a.

Support the transmission with a transmission jack. Lift the transmission slightly from the crossmember.


b.
C176551

Remove the 4 bolts of the rear engine mounting insulator.


c.
C176552

Remove the 4 bolts, 4 nuts, 4 washers and frame crossmember.


Hide 12371 26.REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

a.
C176553

Remove the 4 bolts and engine mounting insulator.


Hide 36407 27.REMOVE TRANSFER BREATHER HOSE SUB-ASSEMBLY (for 1GR-FE)

a.
C172728

Disconnect the breather hose from the transfer and actuator, and disconnect the 2 clamps.


b.
C172948

Disconnect the 5 clamps.


c.
C172729

Disconnect the 2 breather hoses from the bracket.


Hide 36407 28.REMOVE TRANSFER BREATHER HOSE SUB-ASSEMBLY (for 1VD-FTV)

a.
C172728

Disconnect the breather hose from the transfer and actuator, and disconnect the 2 clamps.


b.
C172949

Disconnect the 3 clamps.


c.
C172727

Disconnect the 3 breather hoses from the bracket.


d.

Remove the bolt and disconnect the bracket from the transmission.


Hide 29.DISCONNECT WIRE HARNESS (for 1GR-FE)

a.
C172711

Disconnect the 2 connectors and 3 clamps.


b.
C172714

Remove the bolt and disconnect the ground cable.


c.

Tilt the transmission downward.

NOTICE:

Make sure the cooling fan does not contact the fan shroud.



d.
C172951E02
0.104,0.104 0.854,0.417 0.75,0.313 10 false LH Side: 0.104,2.417 1.052,2.677 0.948,0.26 10 false RH Side:

Remove the 2 bolts.


e.

Disconnect the back-up light switch connector.


f.

Disconnect the 6 clamps.


Hide 30.DISCONNECT WIRE HARNESS (for 1VD-FTV)

a.
C172711

Disconnect the 2 connectors and 3 clamps.


b.
C172714

Remove the bolt and disconnect the ground cable.


c.

Tilt the transmission downward.

NOTICE:

Make sure the cooling fan does not contact the fan shroud.



d.
C172950

Disconnect the shift position switch connector.


e.

Disconnect the back-up light switch connector.


f.

Disconnect the 5 clamps.


Hide 31121 31.REMOVE NO. 1 CLUTCH HOUSING COVER

C172725

a.

Remove the 3 bolts and clutch housing cover.


Hide 31482D 32.REMOVE CLUTCH RELEASE CYLINDER TO ACCUMULATOR TUBE

Hide 31490 33.REMOVE CLUTCH ACCUMULATOR ASSEMBLY

Hide 31470 34.REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY

C179745

a.

Remove the 2 bolts and pull out the clutch release cylinder.


Hide 31482 35.REMOVE CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE

C179744E02
0.073,0.104 1.052,0.375 0.979,0.271 12 false for 1GR-FE: 0.073,2.323 1.365,2.594 1.292,0.271 12 false for 1VD-FTV:

a.

Remove the 3 bolts and flexible hose tube.


Hide 12140 36.REMOVE OIL PAN COVER (for 1VD-FTV)

C172956

a.

Remove the 2 bolts and oil pan cover.


Hide 37.REMOVE MANUAL TRANSMISSION WITH TRANSFER (for 1GR-FE)

C176669

a.

Remove the 9 bolts and manual transmission with transfer.


Hide 38.REMOVE MANUAL TRANSMISSION WITH TRANSFER (for 1VD-FTV)

C176668

a.

Remove the 10 bolts and manual transmission with transfer.


Hide 31204 40.REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY