Home › Vehicle Exterior › DOOR / HATCH › FUEL LID LOCK CONTROL CABLE ASSEMBLY (for LHD) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255751 FUEL LID LOCK CONTROL CABLE ASSEMBLY(for LHD) A

DOOR / HATCH  FUEL LID LOCK CONTROL CABLE ASSEMBLY(for LHD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 77035 1.INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY

a.

Connect the cable to the clamps shown in the illustration to install the cable.

B181052


Hide 77377 2.INSTALL FUEL FILLER OPENING LID LOCK RETAINER

B181055

a.

Install the lock retainer and turn it clockwise as shown in the illustration.


b.
B181056

Install the cable and turn it clockwise as shown in the illustration.


Hide 77306 3.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY

a.
B181065

Connect the fuel lid lock control cable to the fuel lid lock open lever.


b.

Attach the 2 claws to install the fuel lid lock open lever.


Hide 71845B 5.INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

Hide 64937A 6.INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

Hide 55317A 24.INSTALL INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)

Hide 55317A 25.INSTALL INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)

Hide 26.INSTALL REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Seat Type 40 Side)

Hide 27.INSTALL REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Seat Type 60 Side)

Hide 28.INSTALL REAR NO. 1 SEAT ASSEMBLY (for Bench Seat Type)

Hide 64910J 29.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 31.INSTALL FRONT SEAT ASSEMBLY LH

Hide 32.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 33.CHECK SRS WARNING LIGHT