Home › Drivetrain › JF2BM (TRANSFER / 4WD / AWD) › TRANSFER SYSTEM › from 2021.07
RM38G0E _52 Drivetrain _100437 JF2BM TRANSFER / 4WD / AWD _0467431 TRANSFER SYSTEM T

JF2BM TRANSFER / 4WD / AWD  TRANSFER SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Transfer System
Symptom Suspected Area Link
Noise Oil (Level low) Click here
Oil (Wrong) Click here
Transfer faulty Click here
Oil leakage Oil (Level too high) Click here
Gasket (Damaged) Click here
Oil seal (Worn or damaged) Click here
O-ring (Worn or damaged) Click here
The 4LO indicator light remains off after operating the transfer position switch to L4 ECU power source circuit Click here
CAN communication system Click here
Combination meter assembly
Transfer position switch
4 wheel drive control ECU
The 4LO indicator light remains on after operating the transfer position switch to H4 ECU power source circuit Click here
CAN communication system Click here
Combination meter assembly
Transfer position switch
4 wheel drive control ECU
The 4LO indicator light continues blinking after the transfer position switch is operated ECU power source circuit Click here
High-low shift actuator (transfer shift actuator assembly) Click here
4 wheel drive control ECU
After the center differential lock switch (transfer position switch) is operated, the center differential lock indicator light remains off or illuminated ECU power source circuit Click here
CAN communication system Click here
Combination meter assembly
Center differential lock switch (transfer position switch)
4 wheel drive control ECU
After the center differential lock switch (transfer position switch) is operated, the center differential lock indicator light remains blinking ECU power source circuit Click here
Center differential lock shift actuator (transfer shift actuator assembly) Click here
4 wheel drive control ECU
After the rear differential lock switch is operated, the rear differential lock indicator light remains off or illuminated ECU power source circuit Click here
CAN communication system Click here
Combination meter assembly
Rear differential lock switch
4 wheel drive control ECU
After the rear differential lock switch is operated, the rear differential lock indicator light remains blinking ECU power source circuit Click here
Rear differential lock solenoid (electronic differential lock case sub-assembly) Click here
Rear differential lock position switch (differential lock indicator switch)
4 wheel drive control ECU
After the front differential lock switch is operated, the front differential lock indicator light remains off or illuminated ECU power source circuit Click here
CAN communication system Click here
Combination meter assembly
Front differential lock switch
4 wheel drive control ECU
After the front differential lock switch is operated, the front differential lock indicator light remains blinking ECU power source circuit Click here
Front differential lock solenoid (No. 1 front differential case sub-assembly) Click here
Front differential lock position sensor (No. 1 4 wheel drive position switch)
4 wheel drive control ECU
Multi-terrain select indicator light abnormal Drive mode select switch circuit (for AJA0F and for V35A-FTS) Click here
Drive mode select switch circuit (for AJA0F and for F33A-FTV) Click here
Drive mode select switch circuit (for AC60F) Click here

Blinking: Blinks at 0.5 second intervals (0.5 seconds on and 0.5 seconds off)