Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

SMART KEY SYSTEM > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here



DTC CHECK
If a malfunction code is displayed during the DTC check, check the suspected area listed for that code in the table below, and proceed to the appropriate page.

Smart key system 
DTC No.
Detection Item
Trouble Area
See page
B2271
Ignition Hold Monitor Malfunction
- Power source control ECU
- AM1 fuse
- AM2 fuse
- Wire harness
Click here
B2272
Ignition 1 Monitor Malfunction
- Power source control ECU
- IG1 relay
- Wire harness
Click here
B2273
Ignition 2 Monitor Malfunction
- Power source control ECU
- Wire harness
Click here
B2274
ACC Monitor Malfunction
- Power source control ECU
- ACC relay
- Wire harness
Click here
B2275
STSW Monitor Malfunction
- Power source control ECU
- Wire harness
Click here
B2277
Detecting Vehicle Submersion
- Power source control ECU
Click here
B2278
Engine Switch Circuit Malfunction
- Power source control ECU
- Power switch
- Wire harness
Click here
B2281
"P" Signal Malfunction
- Power source control ECU
- Transmission control ECU
- Wire Harness
Click here
B2282
Vehicle Speed Signal Malfunction
- Power source control ECU
- Combination meter
- Wire Harness
Click here
B2284
Brake Signal Malfunction
- Power source control ECU
- Stop light switch
- Wire Harness
Click here
B2286
Ready Signal Malfunction
- Power source control ECU
- Hybrid vehicle control ECU
- Wire harness
Click here
B2287
LIN Communication Master Malfunction
- Power source control ECU
- Transponder key ECU
- Wire harness
Click here
B2289
Key Collation Waiting Time Over
- Power source control ECU
- Engine immobiliser system
- Wire harness
Click here