PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built from Aug 2007
Versions by build date: Nov 2005 – Dec 2006 Jan 2007 – Jul 2007 from Aug 2007
- HINT:
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| No functions of A/C system operate |
1. ECU-IG2 fuse |
- |
| 2. Wire harness or connector |
- |
|
| 3. Air conditioning amplifier |
Click here
|
|
| Airflow Control: Blower motor does not operate |
1. HTR, ECU-IG1 fuse |
- |
| 2. Blower motor circuit |
Click here
|
|
| 3. Blower motor |
Click here
|
|
| 4. Wire harness or connector |
- |
|
| Airflow Control: Blower motor does not change speed |
1. Blower resistor |
Click here
|
| 2. Blower motor |
Click here
|
|
| 3. Heater control (blower switch) |
Click here
|
|
| Temperature Control: No cool air comes out |
1. Refrigerant volume |
Click here
|
| 2. Refrigerant pressure |
Click here
|
|
| 3. Air conditioning pressure sensor circuit |
Click here
|
|
| 4. Heater control base |
- |
|
| 5. Air mix control knob |
- |
|
| 6. Compressor circuit (for 2GR-FE) |
Click here
|
|
| 7. Compressor lock sensor circuit (for 2GR-FE) |
Click here
|
|
| 8. Compressor solenoid circuit |
Click here
|
|
| 9. Expansion valve |
Click here
|
|
| 10. Air conditioning amplifier |
Click here
|
|
| 11. ECM (for 2AD-FHV) |
Click here
|
|
| 12. ECM (for 2AD-FTV) |
Click here
|
|
| 13. ECM (for 1AZ-FE) |
Click here
|
|
| 14. ECM (for 2AZ-FE) |
Click here
|
|
| 15. ECM (for 2GR-FE) |
Click here
|
|
| 16. CAN communication |
Click here
|
|
| Temperature Control: No warm air comes out |
1. Evaporator temperature sensor circuit |
Click here
|
| 2. Ambient temperature sensor circuit |
Click here
|
|
| 3. Engine coolant temperature sensor circuit (for 2AD-FHV) |
Click here
|
|
| 4. Engine coolant temperature sensor circuit (for 2AD-FTV (for CCo)) |
Click here
|
|
| 5. Engine coolant temperature sensor circuit (for 2AD-FTV (for DPF)) |
Click here
|
|
| 6. Engine coolant temperature sensor circuit (for 1AZ-FE) |
Click here
|
|
| 7. Engine coolant temperature sensor circuit (for 2AZ-FE) |
Click here
|
|
| 8. Engine coolant temperature sensor circuit (for 2GR-FE) |
Click here
|
|
| 9. CAN communication system |
Click here
|
|
| 10. Air mix damper control cable |
Click here
|
|
| 11. Air mix control knob |
Click here
|
|
| 12. Air conditioning amplifier |
Click here
|
|
| 13. ECM (for 2AD-FHV) |
Click here
|
|
| 14. ECM (for 2AD-FTV) |
Click here
|
|
| 15. ECM (for 1AZ-FE) |
Click here
|
|
| 16. ECM (for 2AZ-FE) |
Click here
|
|
| 17. ECM (for 2GR-FE) |
Click here
|
|
| Compressor and pulley do not operate |
1. ECU-IG2 fuse |
- |
| 2. Refrigerant pressure |
Click here
|
|
| 3. Compressor circuit (for 2GR-FE) |
Click here
|
|
| 4. Compressor lock sensor circuit (for 2GR-FE) |
Click here
|
|
| 5. Compressor solenoid circuit |
Click here
|
|
| 6. Air conditioning pressure sensor circuit |
Click here
|
|
| 7. Evaporator temperature sensor circuit |
Click here
|
|
| 8. Heater control base |
Click here
|
|
| 9. Air mix control knob |
Click here
|
|
| 10. Air conditioning amplifier |
Click here
|
|
| 11. ECM (for 2AD-FHV) |
Click here
|
|
| 12. ECM (for 2AD-FTV) |
Click here
|
|
| 13. ECM (for 1AZ-FE) |
Click here
|
|
| 14. ECM (for 2AZ-FE) |
Click here
|
|
| 15. ECM (for 2GR-FE) |
Click here
|
|
| 16. CAN communication |
Click here
|