Home › Engine / Hybrid System › B48 (ENGINE MECHANICAL) › ENGINE WIRE HARNESS (for No. 1)
RM3650E _51 Engine / Hybrid System _080178 B48 ENGINE MECHANICAL _0388850 ENGINE WIRE HARNESS(for No. 1) A

B48 ENGINE MECHANICAL  ENGINE WIRE HARNESS(for No. 1)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.

-

For an auxiliary battery: Disconnect battery earth lead of auxiliary battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 85010 3.REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

Hide 55788A 4.REMOVE COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 11271A 5.REMOVE REAR CYLINDER BLOCK COVER

Hide 17880 7.REMOVE AIR CLEANER HOSE ASSEMBLY

Hide 17882 8.REMOVE NO. 2 AIR CLEANER HOSE

Hide 51219 9.REMOVE FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 12140 10.REMOVE OIL PAN COVER

Hide 11.DRAIN ENGINE COOLANT (for Low Temperature)

Hide 11401T 12.REMOVE CYLINDER BLOCK COVER

Hide 23285A 13.REMOVE NO. 1 CHECK VALVE

Hide 82121 17.REMOVE ENGINE WIRE

a.

Overview: Engine wire

NOTICE:
·

Damage to wires when disconnecting connectors and plug connections.

Sheared wires can cause a short circuit.

-

Do not pull on the wires when disconnecting connectors and plug connections.




A445565


b.
A441490

Unlock and loosen the connector of the vacuum sensor assembly.


c.

Unlock and loosen the connector of the air pressure sensor.


d.

Unlock and loosen the connector of the inlet air temperature sensor.


e.

Unlock and loosen the connector of the No. 4 fuel vapor feed hose.


f.

Unlock and loosen the connector of the water valve.


g.

Unlock and detach the connector of the water pump assembly (for Turbo).


h.

Unlock and loosen the connector of the throttle body with motor assembly.


i.
A441491

Unlock and loosen the connectors of the knock sensors.


j.

Unlock and detach the connector of the generator assembly.


k.

Unlock and detach the connector of the compressor with magnet clutch.


l.

Unlock and detach the connector of the engine coolant temperature sensor (for Engine).


m.

Unlock and detach the connector of the crankshaft position sensor.


n.

Unlock and detach the connector of the oil pressure sensor.


o.

Unlock and loosen the connector of the oil pressure control valve assembly.


p.

Unlock and detach the connector of the engine oil level sensor.


q.

Unlock and detach all clamps.


r.

Feed out the engine wire (1) and remove it.