DTC Table
Precautions: Precautions for Diagnosing Trouble · Precautions for Replacing Remote Controller · Precautions for Remote Controller Disposal · Precautions for Replacing Keyless Start Control Module · Precautions for Control Systems · General safety (00)
NOTE:
•*1: Theft deterrent light blinks.
•*2: “KEY FOB LOW BATTERY” is shown in information display.
•*3: Immobilizer indicator light lights up or blinks. “SERVICE START SYSTEM” is shown in information display.
•*4: Immobilizer indicator light lights up when relay is turned on. “SERVICE START SYSTEM” is shown in information display.
•*5: Immobilizer indicator light lights up (5 seconds). “SERVICE STEERING LOCK SYSTEM” is shown in information display.
•*6: Immobilizer indicator light lights up. (It stays on for 15 minutes when steering lock fails. It stays on for 5 seconds when steering unlock fails and ignition mode is in mode other than “ON”. It stays on continuously when ignition mode is in “ON”). “SERVICE STEERING LOCK SYSTEM” or “TRN.
STEERING WHEEL TO RELEASE LOCK” is shown in information display.
•*2: “KEY FOB LOW BATTERY” is shown in information display.
•*3: Immobilizer indicator light lights up or blinks. “SERVICE START SYSTEM” is shown in information display.
•*4: Immobilizer indicator light lights up when relay is turned on. “SERVICE START SYSTEM” is shown in information display.
•*5: Immobilizer indicator light lights up (5 seconds). “SERVICE STEERING LOCK SYSTEM” is shown in information display.
•*6: Immobilizer indicator light lights up. (It stays on for 15 minutes when steering lock fails. It stays on for 5 seconds when steering unlock fails and ignition mode is in mode other than “ON”. It stays on continuously when ignition mode is in “ON”). “SERVICE STEERING LOCK SYSTEM” or “TRN.
STEERING WHEEL TO RELEASE LOCK” is shown in information display.
| DTC | DTC name | DTC detecting condition | Warning |
|---|---|---|---|
B1102 
|
Mid Inside Antenna | Mid inside antenna ON signal is detected 3 times continuously. | Lights up *1 |
| B1103
|
Rear Inside Antenna | Rear inside antenna ON signal is detected 3 times continuously. | Lights up *1 |
| B1105
|
Driver Side Outside Antenna | Driver side outside antenna ON signal is detected 3 times continuously. | Lights up *1 |
| B1106
|
Passenger Side Outside Antenna | Passenger side outside antenna ON signal is detected 3 times continuously. | Lights up *1 |
| B1107
|
Rear Outside Antenna | Rear outside antenna ON signal is detected 3 times continuously. | Lights up *1 |
| B1120
|
Keyless Start Control Module Internal Defect | Keyless start control module internal failure. | Lights up *3 |
| B1122
|
Backup Power Supply Malfunction | Backup power supply circuit voltage from “BCM” fuse is lower than specified value. | Lights up *1 |
| B1123
|
Backup Power Supply Malfunction | Backup power supply circuit voltage from “DOME” fuse is lower than specified value. | Lights up *1 |
| B1125
|
Clutch / Shift Switch Malfunction |
M/T model: Inconsistency between signals from CPP No.1 switch or CPP No.2 switch and inhibit switch signal transmitted via CAN communication. A/T model: Inconsistency between signals from transmission range sensor or P position switch and transmission shift position signal transmitted via CAN communication. |
Lights up *3 |
| B1126
|
P Position Switch Malfunction | P position switch ON signal is detected while vehicle running. (10 km/h (6 mile/h) or more) | Lights up *3 |
| B1134
|
Remote Controller Battery Low | Remote controller battery run down signal is received from remote controller. | Lights up *2 |
| B1137
|
Brake Light Switch Malfunction | Inconsistency between brake light switch signal and the data signal transmitted via CAN communication. | Lights up *3 |
| B1160
|
Steering Lock Unit Communication Error | No communication is available between keyless start control module and steering lock unit. | Lights up *6 |
| B1161
|
Steering Lock Unit Information Mismatched | Verification error between keyless start control module and steering lock unit. | Lights up *5 |
| B1162
|
Steering Lock Unit Internal Defect |
•Steering lock unit internal failure.
•Lock / Unlock operation failure. |
Lights up *6 |
| B1163
|
Steering Lock Unit Unregistered | No registration of steering lock unit. | Off |
| B1167 | Immobilizer Information Mismatched | Refer to DTC Table:Keyless Push Start Model. | |
| B1168 | Password Mismatched | ||
| B1169 | Registration Failure | ||
| B116A
|
Abnormal Vehicle Speed Pulses From ABS / ESP® Control Module | Vehicle speed signal is not inputted from ESP® control module. | Off |
| B1170
|
EEPROM Access Error | Keyless start control module internal failure. (EEPROM error) | Lights up *3 |
| B1173 | Transponder Unregistered | Refer to DTC Table:Keyless Push Start Model. | |
| B1175 | Immobilizer Information Unregistered | ||
| B1176 | Specification Information Unregistered | ||
| B1180
|
Driver Side Door Request Switch Malfunction | Driver door request switch signal voltage is lower than specified value for specified time. | Lights up *1 |
| B1181
|
Passenger Side Door Request Switch Malfunction | Passenger door request switch signal voltage is lower than specified value for specified time. | Lights up *1 |
| B1182
|
Rear End Door / Trunk Lid Request Switch Malfunction | Rear end door request switch signal voltage is lower than specified value for specified time. | Lights up *1 |
| B1189 | Immobilizer Antenna Communication Error | Refer to DTC Table:Keyless Push Start Model. | |
| B1190
|
Engine Switch Malfunction | Push switch 1 signal voltage and/or push switch 2 signal voltage is not as specified for longer than specified time. | Lights up *3 |
| B1191
|
Accessory Relay Malfunction | Inconsistency between input voltage via “ACC” fuse and ACC relay control condition continuous for longer than specified time. | Lights up *4 |
| B1192
|
Ignition1 Relay Malfunction | Inconsistency between input voltage via “MTR” fuse and IG1 relay control condition continuous for longer than specified time. | Lights up *4 |
| B1193
|
Ignition2 Relay Malfunction | Inconsistency between input voltage via “IG2 SIG” fuse and IG2 relay control condition continuous for longer than specified time. | Lights up *4 |
| B1194
|
Starting Motor Relay Malfunction | Inconsistency between starting motor control relay monitor input voltage and starting motor control relay ON condition is continued for longer than specified time. | Lights up *3 |
| B1461
|
Vehicle Speed Signal Inconsistency | Vehicle speed is not input by CAN communication. | Off |
| U0073
|
Control Module Communication Bus Off | Keyless start control module fails to transmit and receive data via CAN for specified time continuously. | Off |
| U0100
|
Lost Communication With ECM | Receiving error of data from ECM via CAN for specified time continuously. | Off |
| U0101
|
Lost Communication With TCM | Receiving error of data from TCM via CAN for specified time continuously. | Off |
| U0121
|
Lost Communication With ABS / ESP® Control Module | Receiving error of the data from ESP® control module via CAN for specified time continuously. | Off |
| U0140
|
Lost Communication With Body Control Module | Receiving error of data from BCM via CAN for specified time continuously. | Off |
| U0155
|
Lost Communication With Instrument Panel Cluster (IPC) Control Module | Receiving error of data from combination meter via CAN for specified time continuously. | Off |