Fail-Safe Table
Precautions: Precautions for Diagnosing Trouble · Precautions for Replacing Remote Controller · Precautions for Remote Controller Disposal · Precautions for Replacing Keyless Start Control Module · Precautions for Control Systems · General safety (00)
When DTC is detected, keyless start control module enters fail-safe mode as long as malfunction continues to exist but that mode is canceled when keyless start control module recovers normal condition.
| DTC | DTC name | Fail-safe operation |
|---|---|---|
B1102 
|
Mid Inside Antenna | Keyless start control module inhibits door lock operation by request switch. |
| B1103
|
Rear Inside Antenna | Keyless start control module inhibits door lock operation by request switch. |
| B1105
|
Driver Side Outside Antenna | Keyless start control module inhibits door lock operation by request switch. |
| B1106
|
Passenger Side Outside Antenna | Keyless start control module inhibits door lock operation by request switch. |
| B1107
|
Rear Outside Antenna | Keyless start control module inhibits door lock operation by request switch. |
| B1120
|
Keyless Start Control Module Internal Defect | — |
| B1122
|
Backup Power Supply Malfunction | — |
| B1123
|
Backup Power Supply Malfunction | Keyless start control module stops keyless entry system function and door lock function. |
| B1125
|
Clutch / Shift Switch Malfunction | Starting motor control relay is kept ON when engine switch is pressed continuously with ignition “ON”. |
| B1126
|
P Position Switch Malfunction | Steering lock unit is kept unlocked. |
| B1134
|
Remote Controller Battery Low | — |
| B1137
|
Brake Light Switch Malfunction | Depending on the conditions, starting motor control relay is kept ON by either operation of the brake light switch or continuous pressing of engine switch when ignition is “ON”. |
| B1160
|
Steering Lock Unit Communication Error | — |
| B1161
|
Steering Lock Unit Information Mismatched | — |
| B1162
|
Steering Lock Unit Internal Defect | — |
| B1163
|
Steering Lock Unit Unregistered | — |
| B116A
|
Abnormal Vehicle Speed Pulses From ABS / ESP® Control Module | — |
| B1170
|
EEPROM Access Error | Keyless start control module performs controls with default values. |
| B1180
|
Driver Side Door Request Switch Malfunction | Keyless start control module assumes that driver door request switch signal is OFF. |
| B1181
|
Passenger Side Door Request Switch Malfunction | Keyless start control module assumes that passenger door request switch signal is OFF. |
| B1182
|
Rear End Door / Trunk Lid Request Switch Malfunction | Keyless start control module assumes that rear end door request switch signal is OFF. |
| B1190
|
Engine Switch Malfunction |
•Control performed by normally operating side switch when one side brakes down.
•When both sides brake down, engine start / stop and ignition mode changes are inhibited. |
| B1191
|
Accessory Relay Malfunction | — |
| B1192
|
Ignition1 Relay Malfunction | — |
| B1193
|
Ignition2 Relay Malfunction | |
| B1194
|
Starting Motor Relay Malfunction | Starting motor control relay is kept ON when engine switch is pressed continuously. |
| B1461
|
Vehicle Speed Signal Inconsistency | — |