PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| Symptom |
Suspected Area |
See page |
| One side low beam headlight does not illuminate. |
1. H-LP RL fuse or H-LP LL fuse |
- |
| 2. Bulb |
- |
|
| 3. Harness or connector |
- |
|
| 4. Light control ECU (for HID headlight) |
- |
|
| 5. Power distributor (Engine room J/B) |
- |
|
| Both left and right low beam headlights do not illuminate. |
1. H-LP RL fuse and H-LP LL fuse |
- |
| 2. Bulb |
- |
|
| 3. Light control switch circuit |
Click here
|
|
| 4. Headlight relay circuit |
Click here
|
|
| 5. Main body ECU (Instrument panel J/B) |
- |
|
| One side high beam headlight does not illuminate. |
1. H-LP RH fuse or H-LP LH fuse |
- |
| 2. Bulb |
- |
|
| 3. Harness or connector |
- |
|
| 4. Power distributor (Engine room J/B) |
- |
|
| Both left and right high beam headlights do not illuminate. |
1. H-LP RH fuse and H-LP LH fuse |
- |
| 2. Bulb |
- |
|
| 3. Light control switch circuit |
Click here
|
|
| 4. Headlight (HI-BEAM) circuit |
Click here
|
|
| 5. Main body ECU (Instrument panel J/B) |
- |
|
| "High Flash" headlight does not illuminate (Passing function). |
1. Light control switch circuit |
Click here
|
| 2. Main body ECU (Instrument panel J/B) |
- |
|
| Low beam headlights or high-beam headlights do not go off. |
1. Headlight dimmer switch assembly |
Click here
|
| 2. Power distributor (Engine room J/B) |
- |
|
| 3. Harness or connector |
- |
|
| 4. Main body ECU (Instrument panel J/B) |
- |
| Symptom |
Suspected Area |
See page |
| Front parking light does not illuminate. |
1. Bulb |
- |
| 2. Harness or connector |
- |
|
| Rear taillight does not illuminate. |
1. Rear combination light assembly |
Click here
|
| 2. Rear light assembly |
Click here
|
|
| 3. Harness or connector |
- |
|
| License plate light does not illuminate. |
1. Bulb |
- |
| 2. Harness or connector |
- |
|
| Taillight system does not operate (Taillights, parking lights, and license plate lights do not illuminate) |
1. TAIL fuse |
- |
| 2. Taillight relay |
Click here
|
|
| 3. Light control switch circuit |
Click here
|
|
| 4. Taillight relay circuit |
Click here
|
|
| 5. Main body ECU (Instrument panel J/B) |
- |
| Symptom |
Suspected Area |
See page |
| Stop light system does not operate. |
1. Stop fuse |
- |
| 2. Stop light switch |
Click here
|
|
| 3. Stop light control relay (for LHD) |
Click here
|
|
| 4. Stop light control relay (for RHD) |
Click here
|
|
| 5. Rear combination light assembly |
Click here
|
|
| 6. Harness or connector |
- |
|
| One side stop light does not illuminate. |
1. Rear combination light assembly |
Click here
|
| 2. Harness or connector |
- |
|
| High mounted stop light does not illuminate. |
1. High mounted stop light assembly |
- |
| 2. Harness or connector |
- |
| Symptom |
Suspected Area |
See page |
| One side fog light does not illuminate. |
1. Bulb |
- |
| 2. Harness or connector |
- |
|
| Both left and right fog lights do not illuminate (Taillight system is normal). |
1. FR FOG fuse |
- |
| 2. FR FOG relay |
Click here
|
|
| 3. Light control switch circuit |
Click here
|
|
| 4. Front fog light circuit |
Click here
|
|
| 5. Main body ECU (Instrument panel J/B) |
- |
| Symptom |
Suspected Area |
See page |
| Hazard warning lights do not operate (Turn signal lights are normal). |
1. HAZ fuse |
- |
| 2. Hazard warning signal switch (for 2GR-FE RHD) |
Click here
|
|
| 3. Hazard warning signal switch (except 2GR-FE RHD) |
Click here
|
|
| 4. Clock assembly (for 2GR-FE RHD) |
Click here
|
|
| 5. Clock assembly (except 2GR-FE RHD) |
Click here
|
|
| 6. Turn signal flasher assembly (for 2GR-FE RHD) |
Click here
|
|
| 7. Turn signal flasher assembly (except 2GR-FE RHD) |
Click here
|
|
| 8. Harness or connector |
- |
|
| Turn signal lights do not operate (Hazard warning lights are normal). |
1. GAUGE No. 1 fuse |
- |
| 2. Headlight dimmer switch assembly (Turn signal switch) |
Click here
|
|
| 3. Turn signal flasher assembly (for 2GR-FE RHD) |
Click here
|
|
| 4. Turn signal flasher assembly (except 2GR-FE RHD) |
Click here
|
|
| 5. Harness or connector |
- |
|
| Hazard warning lights and turn signal lights do not operate. |
1. HAZ fuse and GAUGE No. 1 fuse |
- |
| 2. Bulb |
- |
|
| 3. Turn signal flasher assembly (for 2GR-FE RHD) |
Click here
|
|
| 4. Turn signal flasher assembly (except 2GR-FE RHD) |
Click here
|
|
| 5. Hazard warning signal switch (for 2GR-FE RHD) |
Click here
|
|
| 6. Hazard warning signal switch (except 2GR-FE RHD) |
Click here
|
|
| 7. Headlight dimmer switch assembly (Turn signal switch) |
Click here
|
|
| 8. Clock assembly (for 2GR-FE RHD) |
Click here
|
|
| 9. Clock assembly (except 2GR-FE RHD) |
Click here
|
|
| 10. Harness or connector |
- |
|
| Turn signal lights do not operate in one direction. |
1. Headlight dimmer switch assembly (Turn signal switch) |
Click here
|
| 2. Turn signal flasher assembly (for 2GR-FE RHD) |
Click here
|
|
| 3. Turn signal flasher assembly (except 2GR-FE RHD) |
Click here
|
|
| 4. Harness or connector |
- |
|
| Only one bulb does not operate. |
1. Bulb |
- |
| 2. Harness or connector |
- |
| Symptom |
Suspected Area |
See page |
| One side back-up light does not illuminate. |
1. Bulb |
- |
| 2. Harness or connector |
- |
|
| Both left and right back-up lights do not illuminate. |
1. Bulb |
- |
| 2. GAUGE No. 1 fuse |
- |
|
| 3. Park/Neutral position switch |
Click here
|
|
| 4. Harness or connector |
- |
| Symptom |
Suspected Area |
See page |
| Only interior light does not illuminate. |
1. Bulb |
- |
| 2. Personal light assembly (with Sliding roof) |
Click here
|
|
| 3. Rear Room light assembly (without Sliding roof) |
Click here
|
|
| 4. Harness or connector |
- |
|
| Only ignition key cylinder light does not illuminate. (without Smart Entry and Start System) |
1. Ignition key cylinder light |
Click here
|
| 2. Harness or connector |
- |
|
| Only engine switch illumination does not illuminate. (with Smart Entry and Start System) |
1. Engine switch illumination circuit |
Click here
|
| 2. Main body ECU (Instrument panel J/B) |
- |
|
| Illuminated entry system does not operate normally. |
1. DOME fuse |
- |
| 2. Door courtesy switch circuit |
Click here
|
|
| 3. Door lock position switch circuit |
Click here
|
|
| 4. Interior light circuit |
Click here
|
|
| 5. Engine switch illumination circuit |
Click here
|
|
| 6. Ignition switch circuit |
Click here
|
|
| 7. Harness or connector |
- |
|
| 8. Main body ECU (Instrument panel J/B) |
- |
| Symptom |
Suspected Area |
See page |
| Vanity light does not illuminate. |
1. Bulb |
- |
| 2. Visor assembly (Vanity light switch) |
- |
|
| 3. Harness or connector |
- |
| Symptom |
Suspected Area |
See page |
| Luggage compartment room light does not illuminate. |
1. Bulb |
- |
| 2. Luggage compartment room light assembly |
Click here
|
|
| 3. Luggage compartment door lock assembly (Door courtesy switch) |
Click here
|
|
| 4. Harness or connector |
- |
| Symptom |
Suspected Area |
See page |
| Glove box light does not illuminate. |
1. Bulb |
- |
| 2. Glove box light assembly (for 2GR-FE RHD) |
Click here
|
|
| 3. Glove box light assembly (except 2GR-FE RHD) |
Click here
|
|
| 4. Harness or connector |
- |
| Symptom |
Suspected Area |
See page |
| Driver side door courtesy light does not illuminate. |
1. Bulb |
- |
| 2. Driver side door courtesy light assembly |
Click here
|
|
| 3. Driver side door courtesy switch |
Click here
|
|
| 4. Harness or connector |
- |
|
| Passenger side door courtesy light does not illuminate. |
1. Bulb |
- |
| 2. Passenger side door courtesy light assembly |
Click here
|
|
| 3. Passenger side door courtesy switch |
Click here
|
|
| 4. Harness or connector |
- |
|
| Rear LH door courtesy light does not illuminate. |
1. Bulb |
- |
| 2. Rear LH door courtesy light assembly |
Click here
|
|
| 3. Rear LH door courtesy switch |
Click here
|
|
| 4. Harness or connector |
- |
|
| Rear RH door courtesy light does not illuminate. |
1. Bulb |
- |
| 2. Rear RH door courtesy light assembly |
Click here
|
|
| 3. Rear RH door courtesy switch |
Click here
|
|
| 4. Harness or connector |
- |
| Symptom |
Suspected Area |
See page |
| Front personal lights do not illuminate. |
1. Bulb |
- |
| 2. Personal light assembly |
Click here
|
|
| 3. Harness or connector |
- |
|
| Rear personal lights do not illuminate. |
1. Bulb |
- |
| 2. Rear room light assembly |
Click here
|
|
| 3. Harness or connector |
- |
| Symptom |
Suspected Area |
See page |
| Automatic light control system does not operate normally. |
1. Light control switch circuit |
Click here
|
| 2. Automatic light control sensor circuit |
Click here
|
|
| 3. Ignition switch circuit |
Click here
|
|
| 4. Main body ECU (Instrument Panel J/B) |
- |
| Symptom |
Suspected Area |
See page |
| Light auto turn off system does not operate normally. |
1. Light control switch circuit |
Click here
|
| 2. Door courtesy switch circuit |
Click here
|
|
| 3. Main body ECU (Instrument Panel J/B) |
- |
| Symptom |
Suspected Area |
See page |
| Battery saving function does not operate. |
1. Door courtesy switch circuit |
Click here
|
| 2. Main body ECU (Instrument Panel J/B) |
- |
| Symptom |
Suspected Area |
See page |
| Headlight beam level control does not operate. |
1. Headlight leveling switch |
Click here
|
| 2. Headlight leveling motor |
- |
|
| 3. Harness or connector |
- |
| Symptom |
Suspected Area |
See page |
| AFS does not operate. |
1. Check DTC |
Click here
|
| 2. Power source circuit |
Click here
|
|
| 3. AFS OFF switch circuit |
Click here
|
|
| 4. AFS ECU |
- |
|
| AFS OFF indicator light does not come on when turning the engine switch on (IG). |
1. AFS ECU |
- |
| 2. Combination meter |
- |
|
| 3. Gateway ECU |
- |
- NOTICE:
- Initialize the AFS ECU after the vehicle height changes due to replacement of the suspension or after performing such operations as removal and reinstallation or replacement of the rear height control sensor sub-assembly.
- When the AFS ECU is replaced, the initialization is also necessary.
- Initialize the AFS ECU after the vehicle height changes due to replacement of the suspension or after performing such operations as removal and reinstallation or replacement of the rear height control sensor sub-assembly.