Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM (w/o Brake pedal Load Sensing Switch) › 2017.01–2021.01
RM2850E _54 Brake _073264 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0356879 ANTI-LOCK BRAKE SYSTEM(w/o Brake pedal Load Sensing Switch) T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM(w/o Brake pedal Load Sensing Switch)  PROBLEM SYMPTOMS TABLE  


Use the table below to help determine the cause of a problem. The likely causes of the problem are indicated in descending order. Check each suspected area in order. Repair or replace faulty parts or perform adjustments as necessary.

NOTICE:

When replacing the skid control ECU, sensor, etc., turn the ignition switch off.


HINT:
·

Use the table below to help determine the cause of the problem symptom. The multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Anti-lock Brake System:
Symptom Suspected Area Link
ABS does not operate Check the DTC again and make sure that the normal system code is output. (Click here)
IG power source circuit (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Check the brake actuator assembly with the intelligent tester. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leakage. (Click here)
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU. -
ABS does not operate efficiently Check the DTC again and make sure that the normal system code is output. (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Stop light switch circuit (Click here)
Check the brake actuator assembly with the intelligent tester. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leakage. (Click here)
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU. -
BRAKE PRESSURE INCREASE FUNCTION does not operate Check the DTC again and make sure that the normal system code is output. (Click here)
Master cylinder pressure sensor (Click here)
Vacuum sensor (Click here)
Stop light switch circuit (Click here)
Check the brake actuator assembly with the intelligent tester. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leakage. (Click here)
If the symptoms still occur even after the above circuits in suspected areas have been inspected and proved to be normal, replace the skid control ECU. -
ABS sensor DTC check cannot be done Check the DTC again and make sure that the normal system code is output. (Click here)
TC and CG terminal circuit (Click here)
If the symptoms still occur even after the above circuit in suspected areas has been inspected and proved to be normal, replace the skid control ECU. -
ABS warning light abnormal (Remains on) ABS warning light circuit (Click here)
Skid control ECU -
ABS warning light abnormal (Does not come on) ABS warning light circuit (Click here)
Skid control ECU -
Brake warning light abnormal (Remains on) Vacuum sensor circuit (Click here)
Brake warning light circuit (Click here)
Skid control ECU -
Brake warning light abnormal (Does not come on) Brake warning light circuit (Click here)
Skid control ECU -
Sensor check cannot be done TS and CG terminal circuit (Click here)
Skid control ECU -