w/ Automatic High Beam System:
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
w/ Automatic High Beam System:
If the forward recognition camera has been replaced with a new one, be sure to perform Forward Recognition Camera Learning.
for sequential recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)
for one time recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (for LED Headlight)>REGISTRATION
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Inspect the fuse and bulb for circuits related to this system before performing the following procedure.
| Symptom | Suspected Area | Link |
|---|---|---|
| Hazard warning signal lights do not operate. | Hazard warning switch circuit |
|
| Combination meter assembly |
|
| Symptom | Suspected Area | Link |
|---|---|---|
| Automatic light control system does not operate. | Headlight dimmer switch circuit |
|
| Main body ECU (multiplex network body ECU) |
|