When replacing the skid control ECU (brake booster with master cylinder assembly), sensor, etc., make sure that the power switch is turned off (lock), the stop light switch assembly is off, and 2 minutes have elapsed since the driver door was closed.
If no abnormality is found when inspecting parts, inspect the skid control ECU and ground points for poor connections.
If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, refer to the page for the respective "DTC Code" in the DTC chart.
When 2 or more DTCs are detected, perform circuit inspections one by one until the problem is identified.
Inspect the fuses and relays before inspecting the trouble areas as shown in the table below.
| DTC Code | Detection Item | INF Code | See page |
|---|---|---|---|
| C1241/41 | Low Battery Positive Voltage | 101*1
102*1 551*2 552*2 553*2 |
( )
|
*1: Electronically Controlled Brake System DTC
*2: ABS DTC
| DTC Code | Detection Item | INF Code | See page |
|---|---|---|---|
| C1346/71 | Stroke Sensor Zero Point Learning Malfunction (Test Mode DTC) | - | ( )
|