Perform these procedures after the engine has cooled down.
1.INSPECT DRIVE BELT
2.REPLACE ENGINE OIL AND OIL FILTER
3.INSPECT COOLING AND HEATER SYSTEM
Check that the radiator and condenser are not blocked with leaves, dirt or insects, and clean them if necessary. Also check the hose connection for the installation condition, corrosion, etc.
4.INSPECT ENGINE COOLANT
5.REPLACE ENGINE COOLANT
6.INSPECT OIL COOLER (for 2AR, w/Oil Cooler)
Visually check the oil cooler for leaks.
7.INSPECT EXHAUST PIPES AND MOUNTINGS
Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
28800
9.INSPECT BATTERY
10.REPLACE FUEL FILTER
11.ADD VALVEMATIC SYSTEM (for 3ZR-FAE)
for French Guiana, Guadeloupe, Martinique, Estonia, Latvia, Romania, Macedonia, Bosnia and Herzegovina, Serbia, Montenegro, and Croatia:
Add fuel injector cleaner to the fuel tank.
12.INSPECT WATER SEDIMENT ACCUMULATOR (for Diesel)
17801
13.INSPECT AIR CLEANER FILTER ELEMENT
Remove the air filter.
Check that the air cleaner is not excessively dirty.
If the air cleaner is excessively dirty, replace the air cleaner filter element.
If cleaning the air cleaner filter element, blow compressed air as shown in the illustration to clean it.
Reinstall the air filter.
When an excessive amount of dirt is present, replace the air filter.
77310A
14.INSPECT FUEL TANK CAP GASKET
15.INSPECT FUEL LINES, CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BANDS
Visually check the fuel lines and hoses for cracks, leaks, loose connections, or deformation.
Check for tank band looseness or deformation.