Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2017.01
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM S

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


HINT:
·

If any DTCs are displayed during the DTC check, inspect the circuit listed for those DTCs. For details of each DTC, refer to the page indicated in the DTC chart.

·

Test mode code C1571 is stored during the transition to test mode. This code does not indicate a malfunction since the code will be cleared when the ECU determines that the sensor is normal. The test mode code is cleared simultaneously when test mode is terminated.

·

The EPS warning light remains illuminated during test mode and starts blinking when the speed sensor is determined to be normal.



Power Steering System
DTC Code Detection Item Normal Return EPS Warning Light See page
C1511 Torque Sensor1 Ignition switch ON again Turns on (Click here)
C1512 Torque Sensor2 Ignition switch ON again Turns on (Click here)
C1513 Torque Sensor Deviation Excessive Ignition switch ON again Turns on (Click here)
C1514 Torque Sensor Power Supply Voltage Ignition switch ON again Turns on (Click here)
C1515 Torque Sensor Zero Point Adjustment Undone After calibrating torque sensor zero point Turns on (Click here)
C1516 Torque Sensor Zero Point Adjustment Incomplete Clear DTC Turns on (Click here)
C1517 Torque Hold Ignition switch ON again Turns on (Click here)
C1524 Motor Circuit Malfunction Ignition switch ON again Turns on (Click here)
C1531 ECU Malfunction Ignition switch ON again Turns on (Click here)
C1532 ECU Malfunction Ignition switch ON again Turns on (Click here)
C1533 ECU Malfunction Ignition switch ON again Turns on (Click here)
C1534 ECU Malfunction Ignition switch ON again Turns on (Click here)
C1535 ECU Malfunction - Turns on (Click here)
C1551 IG Power Supply Voltage Malfunction Ignition switch ON again or after normal condition Turns on (Click here)
C1552 PIG Power Supply Voltage Malfunction Ignition switch ON again or after normal condition Turns on (Click here)
C1553 PIG Power Supply Overvoltage Ignition switch ON again or after normal condition Turns on (Click here)
C1554 Power Supply Relay Failure Ignition switch ON again Turns on (Click here)
C1555 Motor Relay Welding Failure Ignition switch ON again Turns on (Click here)
C1581 Assist Map Number Un-Writing Assist map write Turns on (Click here)
C1582 Assist Map Number Mismatch Ignition switch ON again Turns off (Click here)
U0100 Lost Communication with ECM / PCM "A" Ignition switch ON again or after normal condition Turns on (Click here)
U0129 Lost Communication with Brake System Control Module Ignition switch ON again or after normal condition Turns on (Click here)