The vehicle battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. Therefore, before performing troubleshooting, make sure to perform an on-vehicle inspection to confirm that the main body ECU (multiplex network body ECU) power source circuit is normal.*
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
*: w/ Door Control Battery
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom | Suspected Area | Link |
|---|---|---|
| High mounted stop light does not illuminate | Center stop light assembly |
|
| Harness or connector | - |
*1: for HV Model
*2: for Gasoline Model
*: w/ Memory
| Symptom | Suspected Area | Link |
|---|---|---|
| Hazard warning signal lights do not operate | Hazard warning switch circuit |
|
| Combination meter assembly |
|
| Symptom | Suspected Area | Link |
|---|---|---|
| Automatic light control system does not operate | Headlight dimmer switch circuit |
|
| Main body ECU (Multiplex network body ECU) |
|
| Symptom | Suspected Area | Link |
|---|---|---|
| Headlight beam level control does not operate | Headlight leveling switch |
|
| Harness or connector | - | |
| Headlight assembly |
|
*1: for Multi-information Display (4.2 Inch Display)
*2: for Multi-information Display (7 Inch Display)