2005-2008 Yaris · Service Manual COMMUNICATION SYSTEM

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Aug 2005 – Oct 2005

Versions by build date: Aug 2005 – Oct 2005 from Nov 2005

RESULT LIST OF CHECK CAN BUS LINE (LHD) 
Symptom
Suspected area
See page
Open in CAN Main Wire
CAN Main Wire for Disconnection
Click here
Short in CAN Bus Line
Check CAN Bus Lines for Short Circuit
Click here
Short to +B in CAN Bus Line
Check CAN Bus Line for Short to +B
Click here
Short to GND in CAN Bus Line
Check CAN Bus Line for Short to GND
Click here
Open in One Side of CAN Branch Wire
Open in One Side of CAN Branch Line
Click here
RESULT LIST OF CHECK CAN BUS LINE (RHD) 
Symptom
Suspected area
See page
Open in CAN Main Wire
CAN Main Wire for Disconnection
Click here
Short in CAN Bus Line
Check CAN Bus Lines for Short Circuit
Click here
Short to +B in CAN Bus Line
Check CAN Bus Line for Short to +B
Click here
Short to GND in CAN Bus Line
Check CAN Bus Line for Short to GND
Click here
Open in One Side of CAN Branch Wire
Open in One Side of CAN Branch Line
Click here
COMMUNICATION STOP MODE TABLE 
Symptom
Suspected area
See page
"ABS/VSC/TRC*1" not displayed on intelligent tester.
Brake Actuator (Skid Control ECU) Communication Stop Mode
Click here
"ABS/VSC/TRC*2" not displayed on intelligent tester.
ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode
Click here
"EPS" not displayed on intelligent tester.
Power Steering ECU Communication Stop Mode
Click here
"Steering Angle Sensor*2" not displayed on intelligent tester.
Steering Angle Sensor Communication Stop Mode
Click here
"Yaw Rate / Deceleration Sensor*2" not displayed on intelligent tester.
Yaw Rate Sensor Communication Stop Mode
Click here
"Engine" not displayed on intelligent tester.
ECM Communication Stop Mode
Click here
"SRS Airbag" not displayed on intelligent tester.
Center Airbag Sensor Communication Stop Mode
Click here
"Air Conditioner*3" not displayed on intelligent tester.
Air Conditioning Amplifier Communication Stop Mode
Click here
"Combination Meter" not displayed on intelligent tester.
Combination Meter ECU Communication Stop Mode
Click here
"Integrated J/C" not displayed on intelligent tester.
Main Body ECU Communication Stop Mode
Click here
"Entry & Start*4" not displayed on intelligent tester.
Certification ECU Communication Stop Mode
Click here
"ECT*5" not displayed on intelligent tester.
Transmission Control ECU and ECM Communication Stop Mode
Click here

HINT:
  1. *1: w/ ABS
  2. *2: w/ VSC
  3. *3: w/ Air conditioning or PTC heater
  4. *4: Entry and start system
  5. *5: w/ Multi-mode manual transaxle

← HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2005)PROBLEM SYMPTOMS TABLE (from Nov 2005) →