Home › Engine / Hybrid System › B48 (ENGINE MECHANICAL) › TIMING GEAR CASE
RM3650E _51 Engine / Hybrid System _080178 B48 ENGINE MECHANICAL _0388873 TIMING GEAR CASE A

B48 ENGINE MECHANICAL  TIMING GEAR CASE  REMOVAL  


PROCEDURE

Hide 2.REMOVE SPARK PLUG

Hide 15620 3.REMOVE OIL FILTER CAP ASSEMBLY

Hide 12101A 4.REMOVE OIL PAN DRAIN PLUG

Hide 12101A 5.INSTALL OIL PAN DRAIN PLUG

Hide 15620 6.INSTALL OIL FILTER CAP ASSEMBLY

Hide 23801P 7.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY

Hide 23100X 8.REMOVE FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY

Hide 23250 9.REMOVE FUEL INJECTOR ASSEMBLY

Hide 15370J 10.REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

Hide 23285A 11.REMOVE NO. 1 CHECK VALVE

Hide 11201 13.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 15474 14.REMOVE OUTLET TURBO OIL PIPE

Hide 15.SET NO. 1 CYLINDER TO TDC (COMPRESSION)

Hide 13540 16.REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY

Hide 135A0 17.LOOSEN INTAKE CAMSHAFT TIMING GEAR BOLT ASSEMBLY

Hide 135A0A 18.LOOSEN EXHAUST CAMSHAFT TIMING GEAR BOLT ASSEMBLY

Hide 135A0 19.REMOVE INTAKE CAMSHAFT TIMING GEAR BOLT ASSEMBLY

Hide 135A0A 20.REMOVE EXHAUST CAMSHAFT TIMING GEAR BOLT ASSEMBLY

Hide 13050 21.REMOVE CAMSHAFT TIMING GEAR ASSEMBLY

Hide 13070A 22.REMOVE CAMSHAFT TIMING EXHAUST GEAR ASSEMBLY

Hide 11101 24.REMOVE CYLINDER HEAD SUB-ASSEMBLY

Hide 26.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

Hide 12101 27.REMOVE OIL PAN SUB-ASSEMBLY

Hide 11321 28.REMOVE TIMING GEAR CASE

a.
A441343

Unlock the connector (1) and pull it off the crankshaft sensor.


b.
A441644

Remove the No. 1 crank angle sensor plate (1) from the crankshaft.

HINT:

Increment wheel is magnetic. Protect the increment wheel from contact with metallic swarf after disassembly.



c.
A441463

Loosen E8 bolts in the order (11) to (1).

HINT:

Increased force may be necessary during disassembly because the component is bonded with liquid seal packing.



d.

Carefully loosen and remove the timing case cover (A).


Hide 29.REMOVE CRANK POSITION SENSOR

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A441342

Using a 4 mm hexagon socket wrench, unscrew the bolt (1) and remove the crankshaft position sensor (2).


Hide 30.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A441615

Drive out the timing chain cover oil seal (2) from the timing case cover (1).