w/ Automatic High Beam System:
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
w/ Automatic High Beam System:
If the forward recognition camera has been replaced with a new one, be sure to perform Forward Recognition Camera Learning.
for sequential recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)
for one time recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
w/ Entry and Start System:
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Inspect the fuse and bulb for circuits related to this system before performing the following procedure.
| Symptom | Suspected Area | Link |
|---|---|---|
| Hazard warning signal lights do not operate. | Hazard warning switch circuit |
|
| Combination meter assembly |
|
| Symptom | Suspected Area | Link |
|---|---|---|
| Hazard warning signal lights do not operate. | Hazard warning switch assembly |
|
| Turn signal flasher assembly |
|
|
| Harness or connector | - |