THEFT DETERRENT / KEYLESS ENTRY
ENGINE IMMOBILISER SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- REGISTRATION
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- B2796 The key ID code cannot be transmitted to the transponder key ECU assembly (1 trip detection logic*).
- B2799 One of the following conditions is met: ยท Error in communication between ECM and transponder key ECU...
- B279A Communication line (EFIO-IMI) between the ECM and transponder key ECU assembly is stuck high.
- B279C An ECM that is incompatible with immobiliser system is installed.
- B2780 The unlock warning switch assembly is not detected as being on when the ignition switch is ON (1 trip...
- B2784 The antenna coil in the transponder key coil is open/shorted.
- B2793, B2794, B2797, B2798
- B2795 A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection...
- Engine does not Start because No Initial Combustion
- Engine does not Start but Initial Combustion Occurs
- Key Cannot be Registered
- Security Indicator Light Does not Blink
- Preparation
THEFT DETERRENT SYSTEM
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- CUSTOMIZE PARAMETERS
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DATA LIST / ACTIVE TEST
- Engine Hood Courtesy Switch Circuit
- Horn Circuit
- Security Horn Circuit
- Ignition Switch Circuit
- Glass Breakage Sensor ECU Circuit
- Security Indicator Light Circuit
- ECU Power Source Circuit