Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2017.08
RM27T0E _51 Engine / Hybrid System _053656 2TR-FE ENGINE CONTROL _0260420 SFI SYSTEM T

2TR-FE ENGINE CONTROL  SFI SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



SFI System
Symptom Suspected Area See page
Engine does not crank (Does not start) Battery (Click here)
Starter assembly (for 1.4 kW Type) (Click here)
Starter assembly (for 2.0 kW Type) (Click here)
Smart entry and start system (for Start function) (Click here)
Park/neutral position switch assembly (for Automatic Transmission Models) (Click here)
Clutch start switch assembly (for Manual Transmission Models) (Click here)
VC output circuit (ECM 5 V circuit) (Click here)
Starter signal circuit (Click here)
ECM power source circuit (Click here)
No initial combustion (Does not start) Immobiliser system (w/ Entry and Start System) (Click here)
Immobiliser system (w/o Entry and Start System) (Click here)
VC output circuit (ECM 5 V output) (Click here)
ECM power source circuit (Click here)
Crankshaft position sensor (Click here)
Camshaft position sensor (for Intake Side) (Click here)
Camshaft position sensor (for Exhaust Side) (Click here)
Valve timing (Click here)
Ignition system (Click here)
Fuel pump control circuit (Click here)
Fuel injector circuit (Click here)
Starter signal circuit (Click here)
Engine cranks normally but has difficulty in start Engine difficult to start (Click here)
Fuel pump control circuit (Click here)
Engine coolant temperature sensor (Click here)
Ignition system (Click here)
Compression (Click here)
Fuel injector assembly (Click here)
Fuel injector circuit (Click here)
Intake system (Click here)
Throttle body with motor assembly (Click here)
PCV valve and hose (Click here)
Starter signal circuit (Click here)
ECM power source circuit (Click here)
Incomplete intermittent combustion occurs (Does not start) Fuel pump control circuit (Click here)
Fuel pump (for 3 Door) (Click here)
Fuel pump (for 5 Door) (Click here)
Fuel line -
Ignition system (Click here)
Fuel injector circuit (Click here)
ECM power source circuit (Click here)
Starter signal circuit (Click here)
Crankshaft position sensor (Click here)
Camshaft position sensor (for Intake Side) (Click here)
Camshaft position sensor (for Exhaust Side) (Click here)
Valve timing (Click here)
High engine speed Throttle body with motor assembly (Click here)
Intake system (Click here)
A/C signal circuit (for Automatic Air Conditioning System) (Click here)
A/C signal circuit (for Manual Air Conditioning System) (Click here)
ECM power source circuit (Click here)
Engine coolant temperature sensor (Click here)
PCV valve and hose (Click here)
Low engine speed (Poor idle) Throttle body with motor assembly (Click here)
A/C signal circuit (for Automatic Air Conditioning System) (Click here)
A/C signal circuit (for Manual Air Conditioning System) (Click here)
Fuel pump control circuit (Click here)
Fuel pump (for 3 Door) (Click here)
Fuel pump (for 5 Door) (Click here)
Intake system (Click here)
PCV valve and hose (Click here)
Engine stalls on deceleration Engine stalls (Click here)
Idle speed (refer to "Low engine speed" symptom) -
Rough idle Rough idling (Click here)
Compression (Click here)
Ignition system (Click here)
Spark plug (Click here)
Fuel injector circuit (Click here)
ECM power source circuit (Click here)
Fuel pump control circuit (Click here)
Fuel pump (for 3 Door) (Click here)
Fuel pump (for 5 Door) (Click here)
Fuel line -
Throttle body with motor assembly (Click here)
Intake system (Click here)
Purge VSV (Click here)
PCV valve and hose (Click here)
Air fuel ratio sensor (Click here)
Mass air flow meter sub-assembly (Click here)
Knock control sensor (Click here)
Hunting (Poor idle) Electronic throttle control system (Click here)
Intake system (Click here)
ECM power source circuit (Click here)
Drive start control system (Click here)
Hesitation and/or poor acceleration (Poor driveability) Fuel pump control circuit (Click here)
Spark plug (Click here)
Ignition system (Click here)
Fuel injector assembly (Click here)
Mass air flow meter sub-assembly (Click here)
Electronic throttle control system (Click here)
Intake system (Click here)
Compression (Click here)
Brake override system (Click here)
Drive start control system (Click here)
Surging (Poor driveability) Spark plug (Click here)
Fuel pump control circuit (Click here)
Ignition system (Click here)
Fuel injector assembly (Click here)
Mass air flow meter sub-assembly (Click here)
Variable Valve Timing (VVT) system (Click here)
Compression (Click here)
Engine stalls soon after starting Immobiliser system (w/ Entry and Start System) (Click here)
Immobiliser system (w/o Entry and Start System) (Click here)
Fuel pump control circuit (Click here)
Spark plug (Click here)
Ignition system (Click here)
Fuel injector assembly (Click here)
Variable Valve Timing (VVT) system (Click here)
Electronic throttle control system (Click here)
Intake system (Click here)
PCV valve and hose (Click here)
Compression (Click here)
Lack of power Lack of power (Click here)
Brake override system (Click here)
Engine stalls only during A/C operation A/C signal circuit (for Automatic Air Conditioning System) (Click here)
A/C signal circuit (for Manual Air Conditioning System) (Click here)
ECM (Click here)
MIL (malfunction indicator lamp) malfunction MIL Circuit (Click here)
Meter/Gauge system (Click here)
Engine stalls when starting off Automatic transmission system (Click here)
Engine stalls (Click here)
Unable/difficult to refuel Fuel system (canister, roll over valve, fuel tank etc.) -

HINT:

*: Check the "Fuel Cut Elps Time" in the Data List.

If the elapsed time is over 0 sec, then the engine speed is high (More than the engine speed at which fuel cut occurs + 500 rpm).

When this has happened, there is the possibility that the valve rocker arm will become loose and malfunction, so check that the No. 1 valve rocker arm sub-assembly is properly attached (See pageEngine / Hybrid System>2TR-FE (ENGINE MECHANICAL)>CAMSHAFT>REMOVAL ).