Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Initialize the headlight leveling ECU assembly after the vehicle height changes due to replacement of the suspension or after performing such operations as removal and reinstallation or replacement of the rear height control sensor sub-assembly.
When the headlight leveling ECU assembly is replaced, initialization is also necessary.
Camera detection malfunctions can be detected using the GTS.
Aiming misalignment of the camera can be detected using the GTS. If the camera aiming is misaligned, check the following conditions:
Check if the vehicle is inclined.
Check if the windshield glass is installed correctly.
Check if the lane departure warning camera is installed correctly.
Check if there is deformation of the lane departure warning camera.