| The vehicle width extension lines do not overlap with the predicted path lines when the steering wheel is centered
|
Check the installation of steering wheel
|
-
|
| Steering angle setting (Diagnosis System)
|
( )
|
| Check the installation of rear television camera assembly
|
( )
|
| Height control sensor vehicle height difference setting
|
( )
|
| Rear television camera optical axis adjustment
|
( )
|
| Parking assist ECU
|
( )
|
| The predicted path lines stop before the steering wheel is turned to the lock position
|
Steering angle setting (Diagnosis System)
|
( )
|
| "Check IPA System. Have your vehicle checked by a dealer." is displayed on the intelligent parking assist screen
|
Parking assist ECU
|
( )
|
| Projected course guide lines are not displayed on the intelligent parking assist screen
|
Parking assist ECU
|
( )
|
| "System initializing." is displayed
|
Correct the steering angle neutral point
|
( )
|
| "System initializing." is displayed though the steering angle neutral point has been corrected
|
Spiral cable with sensor sub-assembly
|
( )
|
| Steering angle setting (Diagnosis System)
|
( )
|
| Parking assist ECU
|
( )
|
| "System not ready." is displayed
|
Parking assist ECU initialization
|
( )
|
| "System not ready." is displayed though the parking assist ECU initialization has been performed
|
Parking assist ECU
|
( )
|
| Assist operation stops frequently ("System cannot assist under current conditions." is displayed)
|
Inspect the tires (tire size, tire pressure, tire wear)
|
-
|
| Parking assist ECU
|
( )
|
| Assist operation stops frequently ("Use on flat surface." is displayed)
|
Parking assist ECU
|
( )
|
| The set parking position and actual parking position are misaligned either to the right or left in parallel parking mode
|
Parallel parking offset (Diagnosis System)
|
( )
|
| A rear bumper edge and a bumper reference line swerve at the intelligent parking assist screen
|
Check the installation of the rear television camera assembly
|
( )
|
| Height control sensor vehicle height difference setting
|
( )
|
| Rear television camera optical axis adjustment
|
( )
|
| Parts of the bumper reference line are not displayed
|
Height control sensor vehicle height difference setting
|
( )
|
| Rear television camera optical axis adjustment
|
( )
|
| The vehicle does not move to the set parking position
|
Proceed to "Vehicle does not move to set parking position"
|
( )
|
| When the target parking position is set, the initial display position of the target parking space is very far from the actual parking position
|
Notes for ultrasonic sensor (Precaution)
|
( )
|
| No. 1 ultrasonic sensor
|
( )
|
| Front bumper cover
|
( )
|
| Parking assist ECU
|
( )
|
| "CHK" message(s) are displayed on the SIGNAL CHECK screen
|
Proceed to ""CHK" message(s) are displayed on the SIGNAL CHECK screen"
|
( )
|
| When adjusting the camera optical axis, "Back door is open. Do not use the rear view monitor when the back door is not completely closed." is displayed even after the luggage compartment door has been closed
|
Check that the No. 1 luggage compartment light assembly illuminates normally (if not, refer to Lighting System (INT) - Problem Symptoms Table)
|
( )
|
| Parking assist ECU
|
( )
|