w/ Entry and Start System:
Before replacing the Main body ECU (multiplex network body ECU), refer to Service Bulletin.
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>INITIALIZATION
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
| Symptom | Suspected Area | Link |
|---|---|---|
| License plate light does not illuminate | License plate light assembly |
|
| Harness or connector | - |
| Symptom | Suspected Area | Link |
|---|---|---|
| High mounted stop light does not illuminate | Center stop light assembly |
|
| Center stop light cord assembly |
|
|
| Harness or connector | - |
| Symptom | Suspected Area | Link |
|---|---|---|
| Hazard warning signal lights do not operate | Hazard warning switch circuit |
|
| Combination meter assembly |
|