Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


If there are no DTCs output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page.

NOTICE:
When replacing the master cylinder solenoid, sensor, etc., turn the ignition switch off.


VEHICLE STABILITY CONTROL SYSTEM 
Symptom
Suspected Area
See page
ABS, BA and/or EBD does not operate
1. Check the DTC again and make sure that the normal system code is output.
Click here
2. IG power source circuit
Click here
3. Front speed sensor circuit
Click here
4. Rear speed sensor circuit
Click here
5. Check the hydraulic brake booster using intelligent tester. If abnormal, check the hydraulic circuit for leakage
Click here
6. If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid.
Click here
ABS, BA and/or EBD does not operate efficiently
1. Check the DTC again and make sure that the normal system code is output.
Click here
2. Front speed sensor circuit
Click here
3. Rear speed sensor circuit
Click here
4. Stop light switch circuit
Click here
5. Check the hydraulic brake booster using intelligent tester. If abnormal, check the hydraulic circuit for leakage
Click here
6. If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid.
Click here
VSC and/or TRAC does not operate
1. Check the DTC again and make sure that the normal system code is output.
Click here
2. IG power source circuit
Click here
3. Check the hydraulic circuit for leakage
-
4. Front speed sensor circuit
Click here
5. Rear speed sensor circuit
Click here
6. Yaw rate and acceleration sensor circuit
Click here
7. Steering angle sensor circuit
Click here
8. If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid.
Click here
Sensor and switch signal check cannot be done
1. TS and CG terminal circuit
Click here
2. Master cylinder solenoid
Click here
DTC check cannot be performed
1. Check the DTC again and make sure that the normal system code is output.
Click here
2. TC and CG terminal circuit
Click here
3. If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the master cylinder solenoid.
Click here
ABS warning light abnormal (Remains on)
1. ABS warning light circuit
Click here
2. Master cylinder solenoid
Click here
ABS warning light abnormal (Does not come on)
1. ABS warning light circuit
Click here
2. Master cylinder solenoid
Click here
VSC TRAC warning light abnormal (Remains on)
1. VSC TRAC warning light circuit
Click here
2. Master cylinder solenoid
Click here
VSC TRAC warning light abnormal (Does not come on)
1. VSC TRAC warning light circuit
Click here
2. Master cylinder solenoid
Click here
BRAKE warning light abnormal (Remains on)
1. BRAKE warning light circuit
Click here
2. Master cylinder solenoid
Click here
BRAKE warning light abnormal (Does not come on)
1. BRAKE warning light circuit
Click here
2. Master cylinder solenoid
Click here
VSC OFF indicator light abnormal (Remains on) (*2)
1. 4WD control (4WD) switch circuit (*3)
Click here
2. VSC OFF indicator light circuit
Click here
3. Master cylinder solenoid
Click here
VSC OFF indicator light abnormal (Does not come on) (*2)
1. 4WD control (4WD) switch circuit (*3)
Click here
2. VSC OFF indicator light circuit
Click here
3. Master cylinder solenoid
Click here
AUTO LSD indicator light abnormal (Remains on) (*1)
1. AUTO LSD indicator light circuit
Click here
2. Master cylinder solenoid
Click here
AUTO LSD indicator light abnormal (Does not come on) (*1)
1. AUTO LSD indicator light circuit
Click here
2. Master cylinder solenoid
Click here
DAC indicator light abnormal (Remains on) (*3)
1. 4WD control (L4) switch circuit
Click here
2. 4WD control (4WD) switch circuit
Click here
3. DAC indicator light circuit
Click here
4. Master cylinder solenoid
Click here
DAC indicator light abnormal (Does not come on) (*3)
1. 4WD control (L4) switch circuit
Click here
2. 4WD control (4WD) switch circuit
Click here
3. DAC indicator light circuit
Click here
4. Master cylinder solenoid
Click here
SLIP indicator light abnormal (Remains on)
1. SLIP indicator light circuit
Click here
2. Master cylinder solenoid
Click here
SLIP indicator light abnormal (Does not come on)
1. SLIP indicator light circuit
Click here
2. Master cylinder solenoid
Click here
Skid control buzzer abnormal
1. Skid control buzzer circuit
Click here
2. Master cylinder solenoid
Click here
(*1): 2WD (*2): 4WD (*3): Multi Mode 4WD