Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>REGISTRATION
When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
| Symptom | Suspected Area | Link |
|---|---|---|
| Rear fog light does not illuminate | Headlight dimmer switch circuit |
|
| Rear fog light circuit |
|
| Symptom | Suspected Area | Link |
|---|---|---|
| Hazard warning signal lights do not operate. | Hazard warning switch circuit |
|
| Combination meter assembly |
|
| Symptom | Suspected Area | Link |
|---|---|---|
| Automatic light control system does not operate. | Headlight dimmer switch circuit |
|
| Main body ECU (multiplex network body ECU) |
|