Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2014.09–2016.05
RM24M0E _58 Vehicle Interior _059587 METER / GAUGE / DISPLAY _0292197 METER / GAUGE SYSTEM T

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to the system before inspecting the suspected areas below.



Malfunction system
Symptom Suspected Area See page
Entire combination meter does not operate 1. Refer to troubleshooting (Click here)
Operating light control rheostat does not change light brightness 1. Refer to troubleshooting (Click here)
ODO/TRIP switch malfunction 1. Refer to troubleshooting (Click here)
Clock switch malfunction 1. Refer to troubleshooting (Click here)

Meter gauges
Symptom Suspected Area See page
Malfunction in speedometer 1. Refer to troubleshooting (Click here)
Malfunction in tachometer 1. Refer to troubleshooting (Click here)
Malfunction in fuel receiver gauge 1. Refer to troubleshooting (Click here)
Malfunction in engine coolant temperature gauge 1. Refer to troubleshooting (Click here)

Warning light
Symptom Suspected Area See page
MIL remains on 1. Refer to troubleshooting (for 2AZ-FE) (Click here)
2. Refer to troubleshooting (for 2GR-FE) (Click here)
ABS warning light does not come on 1. Refer to troubleshooting (w/ VSC) (Click here)
2. Refer to troubleshooting (w/o VSC) (Click here)
ABS warning light remains on 1. Refer to troubleshooting (w/ VSC) (Click here)
2. Refer to troubleshooting (w/o VSC) (Click here)
Brake warning light does not come on 1. Refer to troubleshooting (w/ VSC) (Click here)
2. Refer to troubleshooting (w/o VSC) (Click here)
Brake warning light remains on 1. Refer to troubleshooting (w/ VSC) (Click here)
2. Refer to troubleshooting (w/o VSC) (Click here)
SRS warning light does not come on*1 1. Refer to troubleshooting (Click here)
SRS warning light remains on 1. Refer to troubleshooting (Click here)
Charge warning light remains on 1. Generator (for 2AZ-FE) (Click here)
2. Generator (for 2GR-FE) (Click here)
3. ECM -
4. Wire harness -
5. Combination meter (Click here)
Engine oil warning light remains on 1. Engine (for 2AZ-FE) (Click here)
2. Engine (for 2GR-FE) (Click here)
3. Engine oil pressure (for 2AZ-FE) (Click here)
4. Engine oil pressure (for 2GR-FE) (Click here)
5. Engine oil pressure switch (Click here)
6. Wire harness -
7. Combination meter (Click here)
Fuel warning light does not come on 1. Refer to troubleshooting (Click here)
Open door warning light does not come on 1. Door courtesy switch (Click here)
2. Wire harness (Click here)
3. CAN communication system (Click here)
4. Main body ECU -
5. Combination meter (Click here)
Driver seat belt warning light does not come on 1. Seat belt buckle switch (Click here)
2. CAN communication system (Click here)
3. Wire harness -
4. Main body ECU -
5. Combination meter (Click here)
Front passenger seat belt warning light does not come on 1. Seat belt buckle switch (Click here)
2. Passenger seat belt warning light (Click here)
3. Wire harness -
4. Combination meter (Click here)
120 km/h warning light does not come on*2 1. VSC system (w/ VSC) (Click here)
2. Anti-lock brake system (w/o VSC) (Click here)
3. CAN communication system (Click here)
4. Combination meter (Click here)
EPS warning light does not come on 1. Power steering ECU (Click here)
2. CAN communication system (Click here)
3. Combination meter (Click here)
Key warning light does not come on 1. Smart entry and start system (for door lock) (Click here)
2. CAN communication system (Click here)
3. Combination meter (Click here)

HINT:

*1: w/ VSC

*2: for G.C.C.


Indicator light
Symptom Suspected Area See page
Turn indicator light does not come on 1. Turn signal light circuit (Click here)
2. Wire harness -
3. Combination meter (Click here)
High beam indicator light does not come on 1. Headlight (HI-BEAM) circuit (Click here)
2. Wire harness -
3. CAN communication system (Click here)
4. Combination meter (Click here)
Front fog light indicator light does not come on 1. Front fog light circuit (Click here)
2. Wire harness -
3. CAN communication system (Click here)
4. Combination meter (Click here)
Rear fog light indicator light does not come on*1 1. Rear fog light circuit (Click here)
2. Wire harness -
3. CAN communication system (Click here)
4. Combination meter (Click here)
CRUISE indicator light does not come on*2 1. CAN communication system (Click here)
2. Combination meter (Click here)
Slip indicator light does not come on*3 1. Refer to troubleshooting (Click here)
Slip indicator light remains on*3 1. Refer to troubleshooting (Click here)
Tail indicator light does not come on 1. Taillight relay circuit (Click here)
2. Wire harness -
3. CAN communication system (Click here)
4. Combination meter (Click here)
Security indicator light does not come on 1. Engine immobiliser system (Click here)
2. CAN communication system (Click here)
3. Combination meter (Click here)
AFS OFF indicator light does not come on*4 1. Lighting system (Click here)
2. CAN communication system (Click here)
3. Combination meter (Click here)
3rd seat indicator light does not come on*5 1. Rear power seat control system (Click here)
2. Wire harness -
3. Combination meter (Click here)
S mode indicator light does not come on*6 1. Park / neutral position switch (for U241E) (Click here)
2. Park / neutral position switch (for U660E) (Click here)
3. Wire harness -
4. ECM -
5. CAN communication system (Click here)
6. Combination meter (Click here)
M mode indicator light does not come on*7 1. Park / neutral position switch (for K112) (Click here)
3. Wire harness -
4. ECM -
5. CAN communication system (Click here)
6. Combination meter (Click here)
VSC OFF indicator light does not come on*3 1. Refer to troubleshooting (Click here)
TRC OFF indicator light does not come on*3 1. Refer to troubleshooting (Click here)

HINT:

*1: w/ Rear Fog Light

*2: w/ Cruise Control

*3: w/ VSC

*4: w/ AFS

*5: w/ Rear Power Seat

*6: for A/T

*7: for CVT


Buzzer
Symptom Suspected Area See page
Seat belt warning buzzer does not sound*1 1. Seat belt buckle switch (Click here)
2. Wire harness -
3. Main body ECU -
4. VSC system (w/ VSC) (Click here)
5. Anti-lock brake system (w/o VSC) (Click here)
6. CAN communication system (Click here)
7. Combination meter (Click here)
Speed warning buzzer does not sound*2 1. VSC system (w/ VSC) (Click here)
2. Anti-lock brake system (w/o VSC) (Click here)
3. CAN communication system (Click here)
4. Combination meter (Click here)
Smart warning buzzer does not sound 1. Smart entry and start system (for door lock) (Click here)
2. Push-button start (for 2AZ-FE) (Click here)
3. Push-button start (for 2GR-FE) (Click here)
4. CAN communication system (Click here)
5. Combination meter (Click here)
Reverse buzzer does not sound*3 1. Park / neutral position switch (for U241E) (Click here)
2. Park / neutral position switch (for U660E) (Click here)
2. Park / neutral position switch (for K112) (Click here)
3. Wire harness -
4. ECM -
5. CAN communication system (Click here)
6. Combination meter (Click here)
Light reminder buzzer does not sound 1. Lighting system (Click here)
2. CAN communication system (Click here)
3. Combination meter (Click here)
Shift reject buzzer does not sound 1. ECM -
2. CAN communication system (Click here)
3. Combination meter (Click here)
Release parking brake warning buzzer does not sound 1. VSC system (w/ VSC) (Click here)
2. Anti-lock brake system (w/o VSC) (Click here)
3. CAN communication system (Click here)
4. Combination meter (Click here)
Key reminder buzzer does not sound 1. Smart entry and start system (for door lock) (Click here)
2. Push-button start (for 2AZ-FE) (Click here)
3. Push-button start (for 2GR-FE) (Click here)
4. CAN communication system (Click here)
5. Combination meter (Click here)
Brake system temperature rise or active test buzzer does not sound*4 1. VSC system (Click here)
2. CAN communication system (Click here)
3. Combination meter (Click here)
Hill-start assist control buzzer (Reset) does not sound*4 1. VSC system (Click here)
2. CAN communication system (Click here)
3. Combination meter (Click here)
Hill-start assist control buzzer (Set) does not sound*4 1. VSC system (Click here)
2. CAN communication system (Click here)
3. Combination meter (Click here)
EPS warning buzzer does not sound 1. Power steering ECU (Click here)
2. CAN communication system (Click here)
3. Combination meter (Click here)
Vehicle roll-away warning buzzer does not sound 1. ECM -
2. VSC system (w/ VSC) (Click here)
3. Anti-lock brake system (w/o VSC) (Click here)
4. CAN communication system (Click here)
5. Combination meter (Click here)

HINT:

*1: w/ Seat Belt Warning Buzzer

*2: for G.C.C.

*3: w/ Reverse Buzzer

*4: w/ VSC